Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
Problem Possible cause Remedial action Electrical function is faulty ( e.g. indicator lamps do not light up) Fuse defective Check fuses in the fuse box and replace if necessary Liquid or runny dough runs to one side Appliance not installed level Check the appliance installation ( see the Installation instructions) ‹ : ‹‹ flashes in the clock display There was a power cut Press the KJ clock function button, reset the clock (see section: Electronic clock) ‹ : ‹‹ flashes on the clock display, "rrr" appears on the temperature display The power supply was interrupted while the appliance was in operation Press the KJ clock function button, reset the clock (see section: Electronic clock) "E011" appears in the clock display. Permanent assignment of a button Cancel the permanent assignment of the button and press the KJ clock function button "EXXX" appears in the clock display, e. g. E300 Internal fault in the appliance electronics Press the KJclock function button. If the message does not go out, pull out the mains plug and plug it back in again after approx. 10 seconds It is not possible to operate the appliance, "Appliance locked" appears on the text display, D and - † - appear on the temperature display. The appliance has been locked Deactivate the lock (see section: Childproof lock) It is not possible to operate the appliance, The appliance controls are locked perma- Deactivate the permanent lock "Appliance permanently locked" appears nently (see section: Childproof lock) on the text display, D and †. appear on the temperature display. The appliance does not heat up, the two A button combination was actuated Switch off the appliance, press and hold dots flash on the clock display ‚‡ ‹© the ± info button for 3 seconds, then press appears in the temperature display, for and hold the KJ clock function button for example 4 seconds, then press and hold the ± info button for 3 seconds Electronically controlled functions are mal- Energy surges (e. g. lightning strike) Reset the function concerned functioning Once you have switched on an operating The appliance has not cooled down fully Wait until the appliance has cooled down, mode, • or oe appears on the temperature then switch on the operating mode again display, and "Not possible" appears on the text display The appliance has switched off automati- The appliance has switched off to protect Turn the operating mode selector back to cally. " Safety switch-off" appears in the text itself from overheating the U position display, ‹ : ‹‹ flashes in the temperature display Smoke is generated during roasting or Fat is burning on the grill element Continue grilling or roasting until the fat on grilling the grill element is burnt away Wire rack or universal pan inserted incor- Place the wire rack in the universal pan rectly and insert them together at a lower shelf height Higher levels of condensation are gener- Normal occurrence ( e. g. when baking Open the appliance door briefly from time ated in the cooking compartment cakes with very moist toppings or roasting to time during operation a large joint) Enamelled accessories have light, matt Normal occurrence caused by dripping Not possible marks meat or fruit juices Door panels are misted up Normal occurrence caused by tempera- Heat the appliance up to 100 °C and then ture differences switch off again after 5 minutes Replacing the oven light bulb Replace faulty oven light bulbs. You can obtain replacement light bulbs from customer service or specialist retailers: E14, 220 - 240 V, 40 W, heat resistant to 300 °C. Only use these oven light bulbs. a= Risk of electric shock ! Disconnect the appliance from the power supply. Switch off the circuit breaker or remove the fuse from the household fuse box. 1. Place a tea towel in the cold cooking compartment to prevent damage. 2. Turn the glass cover anticlockwise and remove it. 3. Replace the oven light bulb with a bulb of the same type. 4. Screw on the glass cover again. 5. Remove the tea towel and switch on the circuit breaker. Note: If the glass cover cannot be unscrewed: use rubber gloves to turn it. You can order a special removal tool through the after-sales service (order no. 613634) Changing the halogen bulbs ( NeffLight ®) Replace faulty halogen bulbs. You can obtain replacement light bulbs from the after- sales service or a specialist retailer: G4 fitting, 12 V, 20 W, heat-resistant to 300 °C. Only use these bulbs. a= Risk of electric shock ! Disconnect the appliance from the power supply. Switch off the circuit breaker or remove the fuse from the household fuse box. a= Risk of burns! Halogen bulbs become very hot when switched on. When replacing them, wait until the bulb has cooled down. Caution! Clouding in halogen bulbs: Do not touch halogen bulbs with bare fingers. This causes oils to get onto the glass which are then burnt on and cloud the glass. Use a clean cloth to change the bulb. The halogen bulbs are located on the left- and right-hand sides under the cooking comp...
Эта инструкция также подходит к моделям:Духовые шкафы - B16E74S1/01 (1.77 mb)