Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
Clean in the dishwasher, or in the oven as part of the self-cleaning programme. The rails may be damaged causing them to jam. Accessories Hot soapy water: Soak and clean with a dish cloth or brush. You can remove the hook-in racks for easier cleaning. : Risk of burning due to hot components in the cooking compartment! Wait until the cooking compartment has cooled down. 1. Push the hook-in rack upwards at the front and unhook to the side (figure A). 2. Pull the hook-in rack forwards at the rear and unhook to the side (figure B). .... 3. Clean the hook-in rack with washing-up liquid and a sponge or brush. 4. Align the hook-in rack with the indentation (a) facing downwards, so that the shelf heights match. 5. Insert the hook-in rack at the rear as far as it will go and push to the rear (figure C). 6. Insert the hook-in rack at the front as far as it will go and push downwards (figure D). ........ Detaching and attaching the oven door For cleaning purposes and to remove the door panels, you can detach the oven door. The oven door hinges each have a locking lever. When the locking levers are closed (figure A), the oven door is secured in place. It cannot be detached. When the locking levers are open in order to detach the oven door (Fig. B), the hinges are locked. They cannot snap shut. .... : Risk of injury! Whenever the hinges are not locked, they snap shut with great force. Ensure that the locking levers are always fully closed or, when detaching the oven door, fully open. 25 Detaching the door 1. Open the oven door fully. 2. Fold up the two locking levers on the left and right (figure A). 3. Close the oven door as far as the limit stop. With both hands, grip the door on the left and right-hand sides. Close the door a little further and pull it out (figure B). Attaching the door Reattach the oven door in the reverse sequence to removal. 1. When attaching the oven door, ensure that both hinges are inserted straight into the opening (figure A). 2. The notch on the hinge must engage on both sides (figure B). 3. Fold back both locking levers (figure C). Close the oven door. : Risk of injury! If the oven door falls out accidentally or a hinge snaps shut, do not reach into the hinge. Call the aftersales service. Removing the door cover The oven door cover can become discoloured. To carry out thorough cleaning, you can remove the cover. 1. Open the oven door fully. 2. Unscrew the oven door cover. To do this, undo the left and right screws (figure A). 3. Remove the cover (figure B). Make sure that the oven door is not closed while the cover is removed. The inner panel may be damaged. Clean the cover with a stainless-steel cleaning agent. 4. Replace the cover and secure it in position. 5. Close the oven door. Removing and installing the door panels To facilitate cleaning, you can remove the glass panels from the oven door. When removing the inner panels, pay attention to the sequence in which the panels are removed. In order to reassemble the panels in the correct sequence, use the numbers that appear on each panel. Removal 1. Detach the oven door and lay it on a cloth with the handle facing down. 2. Unscrew the cover at the top of the oven door. To do this, unscrew the left and right screws (fig. A). 3. Lift the top panel up and pull it out and remove the two small seals (fig. B). 4. Unscrew the retaining clips on the right and left. Lift the panel and remove the clips from the panel (fig. C). 5. Remove the seal from the bottom of the panel (fig. D). Pull the seal and remove it up and out. Pull out the panel. 6. Pull the lower panel at an angle, upwards and out. .. .. .. .. .. .. .. .. .. .. .. 7. Do NOT unscrew the left and right-hand screws from the sheet metal part (fig. E). .. Clean the panels with glass cleaner and a soft cloth. : Risk of injury! Scratched glass in the appliance door may develop into a crack. Do not use a glass scraper, sharp or abrasive cleaning aids or detergents. Installation During installation, make sure that the lettering "top right" is upside down at the bottom left of both panels. 1. Insert the lower panel at an angle towards the back (fig. A). 2. Slide in the middle panel (fig. B). .... 3. Stick the retaining clips onto the right and left-hand side of the panel, aligning them so that the retaining carriers are over the screw holes, and then screw into place (fig. C). 4. Hook the seal in to the bottom of the panel again (fig. D). .... 5. Insert the uppermost panel at an angle to the back into the brackets. Take care not to push the seal to the back (fig. E). 6. Insert the two small seals on the left and right of the panel again (fig. F). .... 7. Put the cover back in place and screw it on. 8. Attach the oven door. Do not use the oven again until the panels have been correctly installed. Faults and repairs It is not always necessary to call the after-sales service. Sometimes, you can find a remedy yourself. You will find some tips for troubleshooting in the following table. Malfunction ta...
Эта инструкция также подходит к моделям:Духовые шкафы - B15P52N3GB/49 (1.15 mb)
Духовые шкафы - B15P52S3GB/01 (1.15 mb)
Духовые шкафы - B15P52S3GB/49 (1.15 mb)