Оценок - 4, средний балл: 4
(
)
)
|
Фрагмент инструкции
• Always insert batteries correctly with regard to polarity (+ and -), marked on the battery and the equipment. • Do not short battery terminals. • Do not recharge. • Remove dead batteries immediately and dispose of per local codes. • Do not dispose of batteries in fire. • Keep batteries out of reach of children. • Remove batteries if the device will not be used for several months. "Transporting batteries can possibly cause fires if the battery terminals inadvertently come in contact with conductive materials such as keys, coins, hand tools and the like. The US Department of Transportation Hazardous Material Regulations (HMR) actually prohibit transporting batteries in commerce or on airplanes (i.e. packed in suitcases and carryon luggage) UNLESS they are properly protected from short circuits. So when transporting individual batteries, make sure that the battery terminals are protected and well insulated from materials that could contact them and cause a short circuit." IMPORTANT: • Do NOT use the wrench as a hammer. • Do NOT use extensions on the wrench to increase torque. FEATURES: OPERATING THE AUTO WRENCHTM WARNING: Always use proper eye protection. • Open the Auto Wrench’s TM jaw by pressing the bottom end of the toggle switch located on the handle. • Position the wrench’s jaw around the item to be loosened, tightened or measured. • Then press and hold down the top end of the toggle switch until the wrench’s jaw closes around it and release the button. NOTE: Auto WrenchTM will stay locked in position until otherwise adjusted. • To manually adjust the size of the opening use the thumb wheel to open and close the jaws. USING THE MEASUREMENT SCALE: Auto WrenchTM comes with a built-in measurement scale (standard and metric) to measure nuts, bolts, pipes, hose fittings and more. To Measure: • Open Auto Wrench’sTM jaw by pressing the bottom end of the toggle switch. • Position the wrench jaw around the item to be measured. • Press and hold down the top end of the toggle switch until the wrench jaw closes around the item being measured. The arrow on the moving jaw points to a marker on the measurement scale. This point represents the size of the item being measured. NOTE: To measure in inches, use the standard scale located on the front of the wrench. To measure in millimeters, use the metric scale located on the backside of the wrench. Replacing the Batteries: • Using a phillips tip screwdriver, unscrew the battery compartment cover located on the backside of the wrench. • Remove the battery compartment cover and replace the “AAA” batteries following the (+/-) polarity indicators in the battery compartment. NOTE: For optimum performance, use alkaline batteries. • Replace the battery compartment cover and screw. Troubleshooting There are no user serviceable parts inside except for the batteries. Always insert batteries correctly with regard to polarity (+ and -), marked on the battery and the equipment. For assistance with your product, visit our website for the location of the service center nearest you or call the BLACK & DECKER help line at 1-800-544-6986. Service Information All Black & Decker Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool serv...
Эта инструкция также подходит к моделям:Дрели и шуропопверты - AAW100 (358.06 kb)