Оценок - 1, средний балл: 3
(
)
)
|
Фрагмент инструкции
Wear protective clothing and wash exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the skin may promote absorption of harmful chemicals. WARNING: Use of this tool can generate and/or disburse dust, which may cause serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved respiratory protection appropriate for the dust exposure. Direct particles away from face and body. General Safety Rules WARNING! Read and understand all instructions. Failure to follow all instructions listed below, may result in electric shock, fire and/or serious personal injury. SAVE THESE INSTRUCTIONS • Read and understand drill instruction manual before using this tool. It contains additional safety rules and instructions not covered here. Electrical Safety • Check for wires. plumbing, or hazardous conditions around and obscured by the work surface. Failure to do so may result in electric shock or other personal injury. • Always hold the handle with one hand and the drill with the other hand when driving screws. Contact with “live” wire will make exposed metal parts of tool and drill “live” and shock the operator. Personal Safety • Use safety equipment. Always wear appropriate eye, respiratory, and foot protection. Failure to do so may result in personal injury. • Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep your hair, clothing, and gloves away from moving parts. Loose clothing, jewelry, or long hair can be caught in moving parts. Air vents cover moving parts and should be avoided. • Keep hands and feet away from main body assembly when depressing tool or when holding tool upright with a drill attached which has sufficient weight by itself to depress tool. Injuries may be caused by pinch points and sharp screw tips. • Do not use tool while standing on a ladder or step stool. Overreaching can cause a loss of balance and subsequent fall. Tool Use and Care • Do not expose tool to rain or wet conditions. Discontinue use if hex shaft does not spin freely. Rust may cause moving parts to seize. • Do not use trigger lock on drill if equipped with one. An unsafe condition may result if screw is unintentionally driven. • Always check tool before use: a. Examine for broken parts. b. Turn hex shank by hand to ensure free rotation. c. Verify clear plastic window on sliding barrel is fully closed. d. Verify proper operation of depth adjustment slider. e. Cycle tool once. • If tool is damaged or not functioning properly, have it serviced before using. Many accidents are caused by poorly maintained tools. • After use, always remove drill from tool. Do not store with drill attached to hex shaft. Tool with attached drill can more easily fall if bumped. • For use ONLY with drywall and decking type screws number #6 & #8 Phillips or Robertson head, 1.5 to 3 inches in length. Other screws may jam. • Do not remove screws from the clear tube through the screw filter. A jam may occur. Service • Tool service must be performed only by qualified repair personnel. Service or maintenance performed by unqualified personnel could result in a risk of injury. • When servicing a tool, use only identical replacement parts. Follow instructions in the Maintenance section of this manual. Use of unauthorized parts or failure to follow Maintenance Instructions may create a risk of electric shock or injury. Specific Safety Rules WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: • lead from lead-based paints, • crystalline silica from bricks and cement and other masonry products, and • arsenic and chromium from chemically-treated lumber (CCA). Your risk fro...
Эта инструкция также подходит к моделям:Дрели и шуропопверты - 618492-01 (626.88 kb)
Дрели и шуропопверты - FS100SF (626.88 kb)