Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
Keep proper footing and balance at all times. 15. MAINTAIN TOOLS WITH CARE. Keep tools sharp at all times, and clean for best and safest performance. Follow instructions for lubricating and changing accessories. 16. DISCONNECT TOOLS. When not in use, before servicing; when changing accessories such as blades, bits, cutters, etc. 17. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see that keys and adjusting wrenches are removed from tool before turning it on. 18. AVOID ACCIDENTAL STARTING. Don’t carry plugged-in tool with finger on switch. Extension Cord When using this drill at a considerable distance from power source, a 3-conductor, grounding-type extension cord of adequate size must be used for safety, and to prevent loss of power and over-heating. For a 120-volt tool, the minimum size of the wires in any extension cord up to 75 feet long must be 18-gauge (American Wire Gauge). If the total extension cord length is from 75 to 100 feet, 16-gauge wire is required throughout the extension. 200-volt tools require a minimum wire size of only 18-gauge in extension cord lengths up to 200 feet long. (NOTE: 16-gauge wire is heavier than 18-gauge wire and will carry current for longer distances without a voltage drop.) P.T.I. Safety Rule #12 applies to Extension Cords as well as the Tool Power Cord. Before using cords, inspect them for loose or exposed wires and damaged insulation. Make any needed repairs or replacement before using your power tool. If The Tool Does Not Run First, check your electric outlet by plugging in another tool or lamp. If either of these'doesn’t work, check for blown fuses. If current is present, check plugs and sockets for tight connections. If the tool still won’t run, take or send it to a Black & Decker Service Center for checking and repair. Do not attempt any major repair on your own. Lubrication Self lubricating bearings are used in the tool and periodic relubrication is not required. However, it is recommended that, at least once a year, you take or send the tool to a B&D Service Center for a thorough cleaning, inspection and lubrication of the gear case. Guarantee Black & Decker guarantees, for one year from date of purchase, to correct by repair or parts replacement without charge any defect due to faulty material or workmanship. Simply return the complete unit, transportation prepaid, to any Black & Decker Service Center or Authorized Service Station. Naturally, we assume no responsibility for damage caused by misuse, careless handling or where repairs have been made or attempted by others. No other guarantee, written or verbal, is authorized by us. Important! To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by BLACK & DECKER Service Centers or other qualified service organizations, always using Black & Decker replacement parts. 9 • • MAINTENANCE See‘To®ls-Electric’ THE BLACK & DECKER MFG. CO. Towson, Md. 21204, U.S.A. See‘To®ls-Electri...
Эта инструкция также подходит к моделям:Дрели и шуропопверты - 7010 (2.4 mb)
Дрели и шуропопверты - 7020 (2.4 mb)
Дрели и шуропопверты - 7110 (2.4 mb)
Дрели и шуропопверты - 7120 (2.4 mb)