Оценок - 4, средний балл: 4.5
(
)
)
|
Фрагмент инструкции
With the gear case separated from the diaphragm & motor housing of the Clutch Dymo-Drill motor — • insert & engage a 61-10-0660 retaining nut spanner with the notches in the 06-57-1050 clutch adjustment retaining nut. • with a 1/2" hex socket bit driver attached to a torque wrench, interlock the male hex with the female hex found in the threaded end of the dymo-drill spindle. • turn the torque wrench clockwise • .........., observing the torque reading and tighten the clutch adjustment retaining nut on the rear of the spindle shaft until a value of 25-30 ft-lbs (34-41 Nm) is obtained. Service Tool No. 61-10-0660 Pronto #5441. or equivalent Retaining Nut Spanner 1/2" Hex Bit Socket Driver, Snap-On #psa16, ...
Эта инструкция также подходит к моделям:Дрели и шуропопверты - Dymodrill (136.41 kb)
Дрели и шуропопверты - Dymodrill (136.41 kb)
Дрели и шуропопверты - Dymodrill (136.41 kb)
Дрели и шуропопверты - Dymodrill (136.41 kb)