Оценок - 4, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
THE WORLD’S BEST KITS.™ a 1-800-221-0932 Q © COPYRIGHT 2004 METRA ELECTRONICS CORPORATION 95-2 no TABLE OF CONTENTS Dash Disassembly 1BB7-2001 Cadillac Catera ............................. 1 1BB6-1BBB Cadillac Devllle (Column Shift Only) ............. 1 Kit Preparation 1BB7-2001 Cadillac Catera.............................2 1BB6-1BBB Cadillac Deville (Column Shift Only) ............. 2 Kit Assembly 1BB7-2001 Cadillac Catera / 1BB6-1BBB Cadillac Deville ( Column Shift Ony) DDIN Head Unit Provision..............................3 ISO Stacked Head Unit Provision......................... 3 knowledge is power Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto or call 800-354-6782 for more information and take steps toward a better tomorrow. Metra recommends using MECP certified technicians. 95-2 10 DASH DISASSEMBLY 1997-2001 CADILLAC CATERA 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Remove (1) Phillips head screw from inside the ashtray and remove ashtray. (Figure A) 3 Remove screw covers from the radio trim panel. Remove traction control and hazard switch covers. Then remove switches by depressing tabs and pulling outward. (Figure B) 4 Remove (4) Phillips head screws from behind covers and ashtray. 5 Remove radio trim panel and unplug any remaining harnesses from the panel. (Figure C) 6 Remove (2) Phillips head screws securing the radio. Unplug and remove the radio. 1996-1999 CADILLAC DEVILLE 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Unsnap and remove radio trim panel. (Open glove box to access.) (Figure A) 3 Pinch the side clips to disengage radio. Unplug and remove radio. 1 95-г 10 KIT PREPARATION 1997-2001 CADILLAC CATERA 1 Cut and remove the three shaded tabs on both brackets. (Figure A) 1996-1999 CADILLAC DEVILLE 1 Cut and remove the shaded tab from both brackets, and both of the tabs on the trim plate. (Figure B) 2 Install (4) speed clips into the subdash mounting positions. (Figure C) 2 95-2 30 KIT ASSEMBLY DOUBLE DIN / STACKED ISO DIN HEAD UNIT PROVISIONS 1 Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter from Metra or AXXESS. Re-connect the negative battery terminal and test the unit for proper operation. 2 Attach the Double DIN brackets to the inside edge of the Double DIN trim plate. (Figure A) 3 Slide the bracket/radio housing assembly over the Double DIN head unit and secure using the screws supplied with the radio. (Figure B) 4 Reassemble dash in reverse order of disassembly. 3 95-2 DD NOTES 4 95-2 D NOTES 5 METRA. THE WORLD’S BEST KITS.™ S 1-800-221-0932 Q REV. 12/01/09 © COPYRIGHT 2004 METRA ELECTRONICS CORPORATION INST95-2004...