Оценок - 2, средний балл: 3
(
)
)
|
Фрагмент инструкции
Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury, death and/or property damage! Retain instructions for future reference. Framing Nailer BUILT TO LAST Note: This framing nailer is shipped Each time the Work Contact Element is with the BLACK single cycle mode depressed, a nail is driven into the trigger installed. work surface. Extreme care should be ! WARNING taken because a nail will be driven Always know the when the WCE is pressed against any mode of the nailer before using. surface. Failure to know the operational operational Since the tool can be actuated without mode could result in death or seri removing the finger from the trigger, ous personal injury. this is considered to be a less restrictive Operational Modes mode, suitable for more experienced users. This stick framing nailer may be operat- MODE CONVERSION ed in the “Single Cycle” or the “Bottom Trip” mode. The nailer is delivered in To convert the tool from one mode to the single cycle mode. A separate ‘red’ the other: trigger for “Bottom Trip” mode is 1. Remove o-ring on the side of trig- included with tool as an accessory. ger pin. 2. Remove trigger pin, trigger, and trigger spring. SINGLE CYCLE MODE 3. Switch out only the trigger. When the black trigger is installed, 4. Replace trigger spring, trigger, trig- nailer is in single cycle mode. This ger pin, and o-ring. method is recommended when precise nail placement is required. Operation Do not attempt to modify the trigger in this mode requires trigger to be components in any manner and do not pulled each time a nail is driven. Nailer attempt to use any other trigger com can be actuated by depressing the Work Contact Element (WCE) against work surface followed by pulling the Mode Conversion trigger. The trigger must be released after each fastener is driven to allow tool to reset. Since the tool can only be actuated by first removing the finger from the trigger, this is considered to be a more restrictive mode of operation, suitable for less experienced users. BOTTOM TRIP MODE When the red trigger is installed, the nailer is in bottom trip mode. This Trigger method is recommended when less precise nail placement is required. Operation in this mode requires trigger to be depressed with nailer off of the work surface. Then, the nose of the nailer is tapped against the work surface causing a nail to be driven. ponents other than those intended for this tool.See the tool manual for further Safetyand Operation information. Contact your Campbell Hausfeld repre-sentative if you have any questions. Campbell Hausfeld nailer meet or exceed IN704300AV 8/05Standard Institute/International Staple, © 2005 Campbell Hausfeld For parts, product & service information visit 4 Feuillet D’Instructions Modeles NS3490 et NS2190 Hoja de Instrucciones Modelos NS3490 y NS2190 Hoja de Instrucciones Modelos NS3490 y NS2190 S’il vous plait lire et conserver ce...
Эта инструкция также подходит к моделям:Домашние кинотеатры - NS2190 (94.03 kb)