Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
2 input indicator When the input source changes, this indicator lights. The indicator’s color changes as noted below. Light OFF - AUX IN Lights blue - AirPlay Lights red - iPod Lights green - DLNA (DMR) Digital Media Renderer 3 network indicator When the network status changes, this indicator lights. The indicator’s color changes as noted below. Lights blue - good connection Flashes blue - weak signal Flashes red - connection failure *In the event that other colors appear, see Network setting on page 18. 4 Battery indicator (XW-SMA3 only) Displays the built-in battery charge status, or lights when the built-in battery is being charged. The indicator changes as noted below. • When the unit is connected to AC adapter Lights blue - Battery charging is completed. *When battery charging is completed on the standby mode, the indicator lights off. Lights purple - Battery is being charged. *If the battery indicator intermittently lights purple, see Additional information on page 37. • When this unit is not connected to AC adapter Lights blue - Battery charge is usable. Lights red - Battery has less than one-half charge. Flashes red - Battery charge is low. *A fully charged battery provides approximately 4 hours of use at maximum volume and approximately 6 hours at 50 % volume. *The battery indicator is not designed to function as an accurate measure of remaining battery charging. *If the battery indicator intermittently lights purple, see Additional information on page 37. 5 . standby/on button Switches the unit between Standby and On. 15 En Part names and functions 03 Part names and functions 03 6 input button Note Select the input source. • When pressing the input button for 3 seconds while this iPod . AUX IN . iPod (return to the beginning) unit is power on, this unit switches to the Quick Start *When AirPlay or DMR play begins, the unit’s input Mode. In the Quick Start Mode, when AirPlay or DMR is function automatically switches respectively to AirPlay played, this unit automatically turns on (page 35). or DMR. If the power is then turned OFF and later turned ON again, the unit will return to the input • When using the XW-SMA3, the Quick Start Mode can be function last selected before AirPlay or DMR began. set only when the AC adapter is connected. 7 volume –/+ button Use to adjust the listening volume. The listening volume has a range from 0 to 50 (however, the unit is not equipped with a display to visually indicate the volume level). Rear panel Open the terminal cover before connecting other various devices to the unit (XW-SMA3 only). Before making or changing the connections, switch off the power and disconnect the power cord from the AC outlet. network setup wireless direct AUX INDC IN 15 ViPod/iPhone/iPadLAN(10/100) Chief Speaker Engineer SOUND TUNED BY ANDREW JONES 2 3 4 5 6 1 Movable range of the wireless antenna 160° 100° XW-SMA3 Terminal Cover 1 Wireless antenna Caution Receives signals from wireless devices. • The terminal cover may be detached if pulled strongly 2 network setup/wireless direct button away from the unit (XW-SMA3 only). If the terminal cover Use to set the wireless network (page 18). becomes detached, press the cover’s protruding pins into the connector openings on the unit, then use a 3 LAN (10/100) connector narrow non-pointed stick or other implement to push Connect this unit to other network devices using a LAN cable. through from above. Take care not to injure your eyes or fingers when doing this. 4 iPod/iPhone/iPad connector Use to connect iPod/iPhone/iPad as an audio source. This unit does not support any USB device other than iPod/ iPhone/iPad. 5 DC IN terminal Connect to AC adapter. 6 AUX IN jack Use to connect an auxiliary playback device (page 34). 16 En Part names and functions 03 Part names and functions 03 • Do not lift this device by holding the wireless antenna, since damage or personal injury may result. on input network input volume standby/on • When using XW-SMA4, do not lift this device by holding the recessed portion of the rear panel, since damage or personal injury may result. XW-SMA4 network setup wireless direct AUX INDC INiPod/iPhone/iPadLAN(10/100) Chief Speaker Engineer SOUND TUNED BY ANDREW JONES 17 En Connect to network 04 Connect to network 04 Chapter 4: Connect to network Network setting By connecting the unit to your home LAN, you can enjoy AirPlay and playback of music stored on your computer or other device. • For information regarding the format of files supported by this unit, see Playable file formats on page 41. • Methods of connection may vary depending on the device used. Confirm the type of unit, and follow the appropriate instructions. If you select method A, C or E, confirm the LAN cable is not connected to this unit. En o n inp ut ne t w o rk inp ut v o lum e WAN321LANConnecting this unit using wireless LAN WAN321LANWAN321LANon inpu t net wo rk input volume WAN321LANConnecting this unit using wired LAN WAN321LANDHCP When fixed IP must be se...
Эта инструкция также подходит к моделям:Домашние кинотеатры - XW-SMA1-W (5.36 mb)
Домашние кинотеатры - XW-SMA3-K (5.36 mb)
Домашние кинотеатры - XW-SMA3-W (5.36 mb)
Домашние кинотеатры - XW-SMA4-K (5.36 mb)