Оценок - 2, средний балл: 4.5
(
)
)
|
Фрагмент инструкции
! WARNING Never attempt to repair or perform maintenance on the Wine Captain until the electricity has been disconnected. Do not alter or deform electrical plug in any way. The use of an extension cord is not recommended. Altering, cutting of power cord, removal of power plug, or direct wiring can cause serious injury, fire, and/or loss of property and/or life and will void the warranty. CAUTION Do not lift unit by door handle. Failure to clean the condenser on a regular basis can cause the Wine Captain to malfunction. This could void the warranty. The unit must not be installed behind closed doors. Be sure the front grille is free of obstruction. Obstructing free air flow can cause the Wine Captain to malfunction, and may void the warranty. Use only genuine factory replacement parts. 5 Installation The Wine Captain is manufactured in two different sizes. The 15WC will accommodate thirty two (32) 750 ml wine bottles and the 75WC will accommodate sixty (60) 750 ml wine bottles. Unless otherwise noted all documentation pertains to both units. Grille Installation The lower grille should be affixed prior to installing the Wine Captain. To affix the grille complete the following: 1. With a standard blade screwdriver, remove the screw (located toward the middle of the unit, below the door) needed to attach the grille. 2. If the control knob is located in the grille area, remove it by pulling it toward you. 3. Carefully remove the grille from inside the unit. A small screw hole is located toward the top of the middle recessed section of the grille. 4. Place the two hook-hinges (located on the rear bottom side of the grille) on the front lip of the unit base. Swing the grille up into position, aligning the grille and cabinet screw holes. 5. The control knob may only be installed correctly. If you have to force the installation of the knob you may not have it properly aligned with the two control knobs. Preparation Your Wine Captain may be installed as a built-in or freestanding unit. It uses a front vented fan cooled condenser system which provides the ability to be built-in tightly without the need for additional clearance on the sides, top or rear for ventilation. It is recommended that you leave a minimal amount of clearance to install and remove the Wine Captain in the event service is required. The Wine Captain must not be installed behind closed doors. The front grille must be free from obstruction. Obstructing free air flow can cause the Wine Captain to malfunction and may void the warranty. For the best performance the location of the Wine Captain should not be in direct sun light or near a heat source. Level Installation Position the unit on a flat, level surface, capable of supporting the entire weight of the unit when full. 75WC and 15WC This unit contains four adjustable leveling legs. Turn the legs clockwise to raise and counterclockwise to lower. 6 Electrical Requirement Provide a 115 volt, 60 cycle, AC only (normal household) three prong grounded electrical outlet. DO NOT use an extension cord. DO NOT use an adapter to bypass the ground. DO NOT alter or deform the electrical plug in any manner. Reversing The Door Depending upon the location of the unit, it may be desirable to change the side on which the door is mounted. To reverse the door mounting on the 15WC Wine Captain, perform the following: 1. Remove top hinge from cabinet (3 screws). 2. Lift door off bottom hinge. 3. Remove bottom hinge from cabinet (2 screws) and install on opposite side of cabinet. 4. Remove top hinge plate (2 screws) from door and install on bottom, opposite side of door. 5. Remove bottom hinge plate (2 screws) from door and install on top opposite side of door. 6. Replace plastic spacer on bottom hinge and set door in place. 7. Replace plastic spacer on top hinge and install top hinge on cabinet. 8. Adjust as required to assure proper door seal. To reverse the door mounting on the 75WC Wine Captain, perform the following: 1. Remove the bottom hinge (2 screws) from door. 2. Remove top hinge (2 screws) from door. 3. Remove door. 4. Remove top hinge (3 screws) from cabinet. Invert and install on bottom, opposite side of cabinet. 5. Remove bottom hinge (3 screws) from cabinet. Invert and install on top, opposite side of cabinet. 6. Attach top hinge to door. 7. Attach bottom hinge to door. 8. Adjust as required to assure proper door seal. Door Adjustment The Wine Captain door should always be squared to the cabinet to ensure a proper seal. To properly adjust the door, please follow this procedure: 1. Loosen (do not remove) the three screws in the door hinge plate on the top of the cabinet. 2. Align the door so that it is squared to the cabinet. 3. Tighten the three screws on the top hinge plate. 7 Operation Initial Start-Up The Wine Captain is designed to provide different temperature zones within the cabinet. (See introduction for specific temperatures.) This is done so that different types of wine may be maintained at varyin...