Оценок - 4, средний балл: 4.5
(
)
)
|
Фрагмент инструкции
After defrosting is complete, turn the knob to . Check the power cord is properly connected. desired position and close the door. The . Check the power supply in the electrical outlet.cause of increased ice formation may be (blown fuse / circuit breaker) . one of the following: _ . Make sure the appliance is switched on. the door does not seal well (clean the (thermostat knob in operating position) gasket if it is contaminated, or replace it if it is damaged); _ the door is frequently opened or left too Continuous Operation of the long; Cooling System _ the food stored in the appliance was warm; . The door is frequently opened or left open for the food or dish is touching the inner back _ too long. wall. . The door is not properly closed (the door may sag, the gasket may be polluted or damaged). . Perhaps you may have overloaded the appliance. . The reason may be inadequate ventilation of the compressor (assure adequate air circulation). 8 Water is Leaking From the Appliance If the discharge water outlet is clogged, or the defrost water drips over the channel, water will leak from the appliance. . Clean the clogged outlet. . Manually defrost the increased ice layer ( see ice Formation on the Inner rear Wall ). Noise Cooling in this appliance is made possible by cooling the system using a compressor, which will produce certain noise levels. How noisy the appliance is depends on where it is placed, how it is used and how old the appliance is. . During the operation of the compressor the noise of the liquid is heard and when the compressor is not operating, the refrigerant flow is heard. This is a normal condition and it has no influence whatsoever on the lifetime of the appliance. . After starting the appliance, the operation of the compressor and the refrigerant flow may be louder, which does not mean that something is wrong with the appliance and it has no influence on the lifetime of the appliance. Gradually the noise will reduce. . Sometimes unusual and louder noise may be heard. This noise is often a consequence of inadequate installation. _ The appliance must be level and installed on a firm solid base/floor. _ The appliance should not touch the wall or kitchen units standing next to it. Check the accessories on the interior of the appliance, they should be placed correctly in their positions; also check bottles, tins, and other vessels are not touching each other causing rattling and/or vibrations. 9 Changing The Reversible Door CAUTION: To avoid personal injury to yourself and/or property, we recommend someone assist you during the door reversal process. 1. Remove the top hinge assembly and keep them for future use. 2. Remove the bottom hinge assembly and keep them for later use. 3. Remove the plug buttons from the upper left holes and transfer them to the uncovered holes at the right side. Be sure to press the plug buttons firmly into the holes. 4. Take out a new set of top hinge assembly attached and install on the opposite side. 5. Re-install the bottom hinge assembly previously removed in step 2 on the opposite side. 6. Make sure the door assembly is properly aligned on the cabinet before tightening the screws. 7. Remove the door handle and re-install on the opposite side. 8 . Remove the plug buttons from the right doorframe and transfer them to the uncovered holes at the left side. Be sure to press the plug buttons firmly into the holes. The process is now complete. 10 Wine Cooler Warranty MC Sales and Marketing, Inc. warrants each new Wine Cooler to be free from defects in material and workmanship and agrees to remedy any such defect or to furnish a new part(s) (at the company’s option) for any part(s) of the unit that has failed during the warranty period. Parts and labor expenses are covered on this unit for a period of one year after the date of purchase. In addition MC Sales and Marketing, Inc. warrants the compressor (parts only) to be free from defects in material and workmanship for a period of 5 years. The consumer is responsible for all labor and transportation expenses related to the diagnosis and replacement of the compressor after the initial one- year warranty expires. If in the event the unit requires replacement or refund under the terms of this warranty the consumer is responsible for all transportation expenses to return the unit to our factory prior to receiving a replacement unit or refund. A copy of the dated sales receipt / invoice is required to receive warranty service. This warranty covers appliances in use within the continental United States, Puerto Rico and Hawaii. The warranty does not cover the following: . Damages due to shipping damage or improper installation. . Damages due to misuse or abuse. .Content losses due to failure of the unit. . Inside components such as door panels, door shelves, racks, light bulbs etc… . Punctures to the evaporator system due to improper defrosting of the unit. . Repairs performed by unauthorized service agents. . Service calls that do...
Эта инструкция также подходит к моделям:Диспенсеры - MCWC30MCG (1003.34 kb)