Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
BEAD SILICON SEALER (RTV) FLOOR CABINET Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice. Form No. Z2219 3 Rev. 4.15.06 How To Operate – Flat Top Bottle Coolers Temperature Control An adjustable temperature control is located inside the Bottle Cooler on the evaporator fan panel assembly. It is factory set at “Normal” approximately 38° F. Make adjustments as shown to attain the desired temperature. NOTE: A temperature setting that is too low will not allow enough condensing unit “off” time to maintain a frost-free coil. ¦ Colder Temperatures: Turn the adjusting screw clockwise (to the right). ¦ Warmer Temperatures: Turn the adjusting screw counterclockwise (to the left). ¦ Temperature Control “OFF”: Turn the adjusting screw completely counterclockwise to the “O” position until a “click” is noted. The condenser fan motor turns off and on with the compressor. The evaporator fan motor runs continuously. Cleaning the Condenser: ¦ The condenser (located behind the front grille) should be inspected every 30 days, and cleaned, if necessary. Failure to keep the condenser clean will cause a loss in condensing unit efficiency, or compressor failure. Avoiding Stainless Steel Corrosion Cleaning the Doors: ¦ Doors should be periodically removed from the cabinet and inspected for a buildup of foreign materials, such as syrups, beer, etc. Buildups on the underside of the doors, along with the cabinet breaker strips on which they ride, will cause them to bind, and therefore, not function as designed. If dirty, these surfaces should be cleaned with a mild detergent and water and then coated with a silicone lubricating material. Aerosol silicone sprays can be obtained locally at most department or automotive stores. To remove doors: ¦ With door closed, lift it upward by its handle and slide forward until door clears the cabinet top. Use the reverse procedure to reinstall the doors. Cleaning the Cabinet: ¦ Use a damp cloth with a mild detergent and water to clean the inside and outside of the cabinet. Dry thoroughly. Do not allow cleaning agents or large amounts of water to go down the drain. Use an acceptable stainless steel polish to clean all stainless steel surfaces. Never use steel wool or scouring pads to clean stainless steel. Corrosion can be prevented by following product cautions, cleaning instructions and avoiding use of certain chemicals or objects which will cause stainless steel corrosion. STAINLESS STEEL ENEMY ¦ Steel wool or steel scouring pads ¦ Cherry/Orange/Olive juice ¦ Chlorine Bleach ¦ Sharp Objects Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice. Form No. Z2219 4 Rev. 4.15.06 Wiring Diagram – Flat Top Bottle Coolers GREEN PLUG-IN-CORD BLACK WHITE WHITE EVAP. FAN EVAP. FAN 2ND FAN ON 4’ THRU 8’ MODELS TEMPERATURE CONTROL RED BLACK TO CONDENSING UNIT INSIDE OF CONDENSING UNIT HOUSING INSIDE OF...
Эта инструкция также подходит к моделям:Диспенсеры - BC24 Series (337.25 kb)
Диспенсеры - BC36 Series (337.25 kb)
Диспенсеры - BC48 Series (337.25 kb)
Диспенсеры - BC72 Series (337.25 kb)