Оценок - 5, средний балл: 4.4
(
)
)
|
Фрагмент инструкции
Do not under any circumstances cut or remove the third ground prong from the power cord supplied. For personal safety, this appliance must be properly grounded. This appliance requires a standard 120 Volt AC / 60Hz electrical ground outlet with three-prong. Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded. When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet. The cord should be secured behind the appliance and not left exposed or dangling to prevent accidental injury. The appliance should always be plugged into its own individual electrical outlet which has a voltage rating that matches the rating label on the appliance. This provides the best performance and also prevent overloading house wiring circuits that could cause a fire hazard from overheated. Never unplug the appliance by pulling the power cord. Always grip the plug firmly and pull straight out from the receptacle. Repair or replace immediately all power cords that have become frayed or otherwise damaged. Do not use a cord that shows cracks or abrasion damage along its length or at either end. When moving the appliance, be careful not to damage the power cord. • Extension Cord Because of potential safety hazards under certain conditions, it is strongly recommended that you do not use an extension cord with this appliance. However, if you must use an extension cord it is absolutely necessary that it be a UL/CUL-Listed, 3-wire grounding type appliance extension cord having a grounding type plug and outlet and that the electrical rating of the cord be 120 volts and at least 10 amperes. 3 OPERATING YOUR WINE COOLER • Setting the Temperature Control • To control the internal temperature, adjust the control dial according to the ambient temperature or purpose of use. • The first time you turn the unit on, set the temperature control to “5” (coldest setting). • The temperature range to control is 4.~10., and the relative setting position is from “5” to “0”. After 24 to 48 hours, adjust the temperature control to the setting that best suites your needs. The setting of “3” should be correct for home or office Wine Cooler use. NOTE: • If the unit is unplugged, has lost power, or turned off; you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the Wine Cooler will not start. • Storage Capacity NOTE: You can place 19 standard bottles in this Wine Cooler. Many bottles may differ in size and dimensions. As such the actual number of bottles you may be able to store may vary. Bottle capacities are approximate maximums when storing traditional Bordeaux 750ml bottles and include bulk storage. 4 5 CARE AND MAINTENANCE O Defrosting Your Wine Cooler Defrost the Wine Cooler when the frost accumulated on the evaporator is about 5mm (1/5 inch) thick. Set the thermostat dial to “0” position. Defrosting usually takes a few hours. After defrosting, return the thermostat dial to the desired position. To defrost quickly removeWines from theWine Cooler and leave the door open. Never use a knife or other metal instrument to scrape ice/frost from the evaporator. O Cleaning Your Wine Cooler · Turn the temperature control to "0", unplug theWine Cooler, and remove theWine and shelves. · Wash the inside surfaces with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart of water. · Wash the shelves with a mild detergent solution. · The outside of theWine Cooler should be cleaned with mild detergent and warm water. · Wring excess water out of the sponge or cloth before cleaning the area of the controls, or any electrical parts. · Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with a clean soft cloth. O Reversing the Door Swing of Your Wine Cooler This appliance has the capability of the door opening from either the left or right side. The unit is delivered to you with the door opening from the left side. Should you desire to reverse the opening direction, please follow the instruction as below. 1. Remove the upper hinge cover (1) first. 2. Remove the three screws (2) that hold the upper hinge (3) (right side) to the frame. Take away the upper hinge (3). 3. Lift the door and place it on a padded surface to prevent scratching it. 4. Remove the three screws (6) that hold the lower hinge (4) and remove hinge (4). 5. Remove the plug (5) and move to the right side. 6. Install the lower hinge onto the left side of the lower frame with three screws (6). 7. Set the door to its place making sure the door seat at the lower hinge (4). 8. While holding the door in the closed position secure the upper hinge (3) in the top frame of left side with three screws (2). Please remember that do not tighten the screws until the top of the door is leveled with the counter top. 9. Install the...