Оценок - 3, средний балл: 3
(
)
)
|
Фрагмент инструкции
2. Use pliers to squeeze tabs (B) on the clamps (C), then slide the clamps away from the fuel filter. Twist and pull the fuel lines (D) off the fuel filter. 3. Check the fuel lines for cracks or leaks. Replace if necessary. 4. Replace the fuel filter with an original equipment replacement filter. 5. Secure the fuel lines with the clamps as shown. How To Clean The Air Cooling System -Figure 13 WARNING Running engines produce heat. Engine parts, especially muffler, become extremely hot. Severe thermal burns can occur on contact. Combustible debris, such as leaves, grass, brush, etc. can catch fire. • Allow muffler, engine cylinder and fins to cool before touching. • Remove accumulated debris from muffler area and cylinder area. NOTICE: Do not use water to clean the engine. Water could contaminate the fuel system. Use a brush or dry cloth to clean the engine. This is an air cooled engine. Dirt or debris can restrict air flow and cause the engine to overheat, resulting in poor performance and reduced engine life. Use a brush or dry cloth to remove debris from the finger guard/rotating screen (A). Keep linkage, springs and controls (B) clean. Keep the area around and behind the muffler (C) free of any combustible debris (Figure 13). Make sure that the oil cooler fins (D) are free of dirt and debris. en Storage WARNING Gasoline and its vapors are extremely flammable and explosive. Fire or explosion can cause severe burns or death. When Storing Gasoline Or Equipment With Fuel In Tank • Store away from furnaces, stoves, water heaters or other appliances that have pilot light or other ignition source because they can ignite gasoline vapors. Fuel System Fuel can become stale when stored over 30 days. Stale fuel causes acid and gum deposits to form in the fuel system or on essential carburetor parts. To keep fuel fresh, Not for Reproduction use Briggs & Stratton FRESH START® fuel stabilizer, available as a liquid additive or a drip concentrate cartridge. There is no need to drain gasoline from the engine if a fuel stabilizer is added according to instructions. Run the engine for 2 minutes to circulate the stabilizer throughout the fuel system. The engine and fuel can then be stored up to 24 months. If gasoline in the engine has not been treated with a fuel stabilizer, it must be drained into an approved container. Run the engine until it stops from lack of fuel. The use of a fuel stabilizer in the storage container is recommended to maintain freshness. Engine Oil While the engine is still warm, change the engine oil. Troubleshooting Need Assistance? Go to BRIGGSandSTRATTON.COM or call 1-800-233-3723. Specifications EngineSpecificationsModel290000Displacement29.23ci(479cc) Bore2.677in(68mm) Stroke2.598in(66mm) OilCapacity46--48oz(1.36--1.42L) EngineSpecificationsModel300000Displacement29.23ci(479cc) Bore2.677in(68mm) Stroke2.598in(66mm) OilCapacity46--48oz(1.36--1.42L) EngineSpecificationsModel350000Displacement34.78ci(570cc) Bore2.835in(72mm) Stroke2.756in(70mm) OilCapacity46--48oz(1.36--1.42L) EngineSpecificationsModel380000Displacement38.26ci(627cc) Bore2.972in(75.5mm) Stroke2.756in(70mm) OilCapacity46--48oz(1.36--1.42L) Tune-upSpecifications* Model290000,300000SparkPlugGap0.030in(0.76mm) SparkPlugTorque180lb-in(20Nm) ArmatureAirGap0.008-0.012in(0.20-0.30mm) IntakeValveClearance0.004-0.006in(0.10-0.15mm) ExhaustValveClearance0.004-0.006in(0.10-0.15mm) Tune-upSpecifications* Model350000,380000SparkPlugGap0.030in(0.76mm) SparkPlugTorque180lb-in(20Nm) ArmatureAirGap0.008-0.012in(0.20-0.30mm) IntakeValveClearance0.004-0.006in(0.10-0.15mm) ExhaustValveClearance0.004-0.006in(0.10-0.15mm) * Engine power will decrease 3.5% for each 1,000 feet (300 meters) above sea level and 1% for each 10° F(5.6° C) above 77° F(25° C). The engine will operate satisfactorily at an angle up to 15°. Refer to the equipment operator’s manual for safe allowable operating limits on slopes. ServicePartPartNumberAirFilter--exceptmodel380000394018AirFilter--model380000692519AirFilterPre-cleaner--exceptmodel380000272490AirFilterPre-cleaner--model380000692520Oil--SAE30100028OilFilter--6cmlong492932OilFilter--9cmlong491056 CommonServicePartsnServicePartPartNumberFuelFilter--withfueltank808116FuelFilter--withfuelpump691035FuelFilter--withoutfuelpump298090FuelAdditive5041ResistorSparkPlug491055LongLifePlatinumSparkPlug5066SparkPlugWrench19374SparkTester19368 n We recommend that you see any Briggs & Stratton Authorized Dealer for all maintenance and service of the engine and engine parts. Use only genuine Briggs & Stratton parts. BRIGGSandSTRATTON.COM BRIGGS & STRATTON ENGINE OWNER WARRANTY POLICY September 2008 LIMITED WARRANTY Not for Reproduction Briggs & Stratton Corporation will repair or replace, free of charge, any part(s) of the engine that is defective in material or workmanship or both. Transportation charges on product submitted for repair or replacement under this warranty must be borne by purchaser. This warranty is effective for and is subje...
Эта инструкция также подходит к моделям:Диспенсеры - VANGUARD 290000 (4.37 mb)
Диспенсеры - VANGUARD 300000 (4.37 mb)
Диспенсеры - VANGUARD 380000 (4.37 mb)