Войти:
Оценок - 4, средний балл: 4.3 ( )

Инструкция по эксплуатации EdgeStar, модель TWR120

Производитель: EdgeStar
Размер: 941.29 kb
Название файла: d47c8886-93d4-4c02-9f05-ba2cfc059a6a.pdf
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


5. Shelf- your wine cooler comes with either chrome metal shelves or wooden racks (depending upon the model.) Either style of shelf easily slides in and out. 6. Foot- these levelling legs screw in and out to help level your cooler on slightly unlevel surfaces. 7. Water box- this is located outside the cooler, in the back. It catches water condensed from inside your cooler and holds it for evaporation. 8. Cover- this covers and protects your door hinge. Remove it to access the hinge (if you want to reverse the door swing, for example). 9. Magnetic seal- this gasket ensures a solid, airtight seal between the door and the cabinet. 10. Glass- the tempered glass protects your wine while displaying it. 11. Door frame- open and close your cooler by the door frame or the handle (if included on your model). 3. Installation 1. Remove all interior and exterior packaging. 2. Set up your wine cooler on a level surface. Make sure you have at least 2” clearance on both sides and 4” clearance in the back for ventilation. 3. Clean the interior surface with a little bit of lukewarm water and a soft cloth. 4. If you desire, install the handle as outlined below (if your cooler comes with a handle.) 5. Insert the power cord into the power socket. Make sure the power socket is a grounded 115V~AC / 60Hz socket. 6. Fill the wine cooler with your choice of wine bottles. Allow up to 24 hours of operation for the bottles to reach the desired temperature. 4. Operation The Temperature Control Your wine cooler uses one of two systems for adjusting the thermostat: Digital control- Adjust the temperature using the up and down arrows located on the door of the wine cooler. While you are using the arrows, the temperature you are setting appears on the digital display. After you finish setting the temperature, the digital display will show the current temperature within the cooler. Manual control- Use the temperature adjustment knob located inside the wine cooler to change the temperature. Turn the knob clockwise to lower the temperature or counter clockwise to raise the temperature. Interior Light Your wine cooler has an interior light with an on/off switch. Turn the light on or off by pressing the switch. On digital control units the light switch will be located on the temperature control, on the outside of the door. On manual control units, the light switch will be located on the temperature control, inside the unit. Door Lock Some models of wine cooler have a factory installed lock with keys. The lock is inset into the door. To lock your cooler, insert the key into the lock and turn the key counter clockwise until the metal tab is fully extended. To unlock your cooler, insert the key into the lock and turn clockwise until the metal tab is fully retracted back into the door. Caution: Make sure to keep the key in a safe place and out of reach of children- to prevent child entrapment. Levelling Legs Your wine cooler is shipped with four levelling legs installed. To adjust these levelling legs, carefully lean the cooler to one side (make sure the cooler is empty and the door is secured) and unscrew the levelling legs to make them longer. Screw them in tighter to make them shorter. Note: This cooler is not designed to operate with the levelling legs removed. Handle Some models of wine cooler are shipped with a towel bar-style handle. To install the handle, you will need a Phillips head screwdriver. Look at the left side of the door frame, facing outwards. There are two small holes in the frame. Take the handle and hold it up to the door frame so that the holes in the handle line up with the holes in the door frame. While holding the handle with one hand, insert a screw through the top hole in the handle and screw it into the top hole in the door frame. Then insert a screw in the bottom hole in the handle and screw it into the bottom hole in the door frame. Now insert the small “caps” included into...

Эта инструкция также подходит к моделям:
Диспенсеры - TWR180 (941.29 kb)
Диспенсеры - TWR481 (941.29 kb)
Диспенсеры - TWR281 (941.29 kb)
Диспенсеры - TWR280 (941.29 kb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории