Оценок - 4, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
oven, barbecue, etc. □ Do not plug unit into the same outlet as a refrigerator. □ Unit should not be built-in into a wall recess, cabinet, niche or any type of enclosed area Setting the temperature control: At anytime, you can manually adjust the temperature. Simply press the (▼) button on the control panel to lower the temperature and the (A) button to increase the temperature inside the wine cooler. Important Note: □ The built-in microprocessor will not allow the user to set the temperature below 54*F (12*C) or above 66*F (19*C). Please note that the protection mechanism only works when used under the recommended ambient temperature conditions described in this manual*. □ The temperature which is displayed on the control panel is always the actual interior temperature inside the cabinet, ranging from 54*F (12*C) to 66°F (19*C). After inputting a desired temperature setting. It takes 3 seconds for the display to return to displaying the actual interior temperature. □ The LED background light will turn on when any of the 3 buttons are pressed. * B«cauM of technological limitation . tha Intartor tamp«ratura canbaaat batwaan 54 "F (12*C) and 66 F (19*C) on the control panel only at tha room temperature of 77*F (28*C) Recommended temperatures for chilling wine: Satup C hack 11 at: properly*. Degrees Red Wines: Port /Sherry White /Rose Wines 54-64° F (12-18*C) 50-57° F (10-14°C) 46-54° F (a-12“C) Cleaning instructions: Below is a listing of general cleaning tips that should be noted when cleaning your wine cooler. When cleaning your cooler, be cautious when using any type of cleaning products, some individuals may have allergic reactions to the chemicals in some of these products. By using solvents to dean your cooler, you may damage its finish, hence it is recommended to use mild detergents, baking soda and water. Never spray or squirt any type of liquid onto your cooler. If a spray is needed, spray the liquid onto a doth and then use the moistened doth to rub down the cooler. • Always unplug the wine cooler before deaning. • Wash the inside surface with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart (1 liter) of water. • Wash the racks with a mild detergent solution. • The outside of the wine cooler should be cleaned with a mild detergent solution. • Always dry all the parts with a clean dry doth before plugging the wine cooler back Into the receptacle. AVOID ABRASIVE PRODUCTS SUCH AS SCOURING PADS AND POWDERS. THEY WILL PERMANATELY DAMAGE THE FINISH OF YOUR WINE COOLER In addition to the deaning tips listed above it is recommended to dean the external fan filter of your wine cooler every 6 months as dirt, dust and hair can build up causing the cooling system do not function as efficiently. ALWAYS UNPLUG THE UNIT FROM THE WALL PRIOR TO CLEANING THE FAN FILTER There are 2 effective methods to dean the external fan filter of your wine cooler • A vacuum deaner can be used colled the dirt, dust and hair that has built up • Alternatively compressed air in a container can be used to dean the fan filter of your wine cooler. Ensure to follow the directions of the compressed air container to avoid damage or personal injury. Interior Light Information: The interior light source of the wine cooler consist of LED lighting which is long lasting and very energy efficient. LED lights will usually last for many years, even sometimes lasting longer than the product they have been installed in. If for any reason the LED lights stop burning and you have determined that they do not longer work. Please contact our customer service department toll-free at 1 -800-898-9020 to find the service center nearest you. -4- Troubleshooting Guide: You can easily solve many common problems by trying the suggestions below: SYMPTOM POSSIBLE CAUSE Vibrations • Check to make sure the wine cooler is on a level surface The door will not close property • The wine cooler is not on a level surface • The racks are out of position Fan is always running. • This is simply a function of the cooling system. The lower the setting, the more the fan will run. If the room is warmer than 77°F (25*C). it will run more • The unit has been designed to run continuously when operating at the lower temperatures Unit has no power. • Check the wall outlet for power. Make sure the outlet is not controlled by a wall switch The inside temperature does not seem correct • Make sure the cooling vents on each side of the cooler are not obstructed. Have at least 5 inch (15cm) of space on each side of unit • The unit will have difficulty in cooling if the set temperature is 32*F (0*C) below the ambient temperature. Example: if the ambient temperature is 86°F (30*C). the unit will have difficulty cooling to 54*F (12*C). • When using the unit for the first time, it can take up to 24 hrs to reach the desired temperature The unit does not operate • It may not be plugged into the wa...