Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
• Install a hubcap onto each wheel by aligning the 5 tabs on the hubcap with the 5 slots in the wheel, and then pushing it into place. Ensure that ALL 5 snaps have engaged securely and the hubcap cannot be pulled off. Figure 4 Installing the Front Wheels • Take one of the double wheel sets and locate the small hole in the rotating bracket that is inside the red lever. • Push the front axle into this hole and keep pushing the wheel set onto this axle until you hear an audible click. See Figure 5. • Pull downward on the wheel set to ensure that it has locked into position on the axle. • Repeat this same procedure for the other wheel set. • When assembled properly, both wheel sets Figure 5should rotate and roll smoothly. The Big Caboose Stand-On Triple Instruction Manual Page 4 Front Wheel Locks The front wheels can be either in swivel mode or locked mode. • To put the front wheels in their locked mode, first rotate each wheel set so that the wheels are pointed straight ahead. • Pull up on the lever to engage the small tab on the lever with the slot in the plastic frame sleeve. The lever can be either facing forward or rearward to lock the wheels. See Figure 6. • To unlock the wheels and put them into swivel mode, push down on the lever to disengage Figure 6 the tab from the slot. Installing and Operating the Canopy The following instructions apply to BOTH Canopies • To attach the canopy, position the canopy on the stroller with the thick padded edge toward the front of the stroller. • Line up the male fittings on the canopy with the female fittings on each side of the seat and push downward until the fittings snap into place. See Figure 7. Pull upward on the canopy sides to be sure both are snapped securely in place. • To open the canopy, pull forward on the front edge of the canopy while holding the back edge in place. Once the canopy is fully opened, push down on BOTH side hinges to lock it in the open position. • The canopy can be adjusted into several positions ranging from fully closed to fully extended, or any position in between. • The canopy will ratchet forward or backward to block the sun. Pull forward on the front of the canopy frame tube to rotate it forward. Pull backward on the rear frame tube to rotate it backward. See Figure 8. • To close the canopy, unlock the side hinges and pull the front edge toward the rear of the stroller until folded. See Figure 9. • To remove the canopy, press the lock button on the side of each of the male fittings while pulling upward on the canopy frame. See Figure 10. Page 5 The Big Caboose Stand-On Triple Instruction Manual Figure 7 Figure 8 Figure 7 Figure 8 Figure 9 Figure 10 ! WARNING Possible pinching hazard - Be careful when closing and opening the side hinges so as not to pinch your fingers. Attaching/Detaching the Front Tray The following instructions apply to BOTH Trays • To attach the front tray, line up the female fittings on the tray with the male fittings on each side of the stroller just in front of the seat and push inward until the fittings snap into place. See Figure 11. Pull outward on both sides of the tray to be sure both are snapped securely in place. • To remove the front tray, press the lock button on the side of each of the male fittings while pulling outward on the tray. See Figure 12. Figure 11 Figure 12 ! WARNING The child tray is not a restraint device. Always secure your child with the seat belt and harness. Never lift the stroller by the child tray. Use caution when attaching the child tray when there is a child seated in the stroller. The Big Caboose Stand-On Triple Instruction Manual Page 6 Rear Wheel Brakes • Before placing any child into the stroller or removing them from the stroller, be certain that the rear wheel brakes are engaged. • To engage the rear wheel brakes, push down on the brake lever located on each rear wheel. See Figure 13. The stroller may require slight forward or rearward movement in order to line up the teeth on the brake with each wheel brake cluster. • Check that the brakes are properly applied by attempting to push the stroller backward and forward. • To release the brakes, gently lift up on the brake lever. See Figure 14. Figure 13 Figure 14 ! WARNING Always set BOTH wheel brakes when the stroller is not being pushed so that the stroller will not roll away. Never leave stroller unattended, especially on a hill or incline, as the stroller may tip over or slide. Adjusting the Footrests Both of the footrests can be adjusted to two positions – horizontal or all the way down. • To place the footrest into the horizontal position, pull up on the footrest and position the footrest lower bar into the upper slot at the middle of the plastic bracket on the underside of the footrest. SeeFigure 15. • Ensure that the bar is located securely into this slot on BOTH sides of the footrest. Push down on both sides of the footrest to ensure it is secure. • To place the footrest into the down position, pull up on the footrest t...