Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
Model #7311 Sit N Stand LX Tandem Stroller with Car Seat Snap N Go Attachment System Instruction Manual 01.06 Convenience through innovation and thoughtful design WARNINGS WARNING: Please follow all of these instructions to ensure the safety of your child. Keep these instructions for future reference. WARNING: Failure to follow these instructions could result in serious injury or death. Avoid serious injury from falling or sliding out. Always use the safety belts and insure that the children are properly positioned according to these instructions. WARNING: Never leave children unattended. * The maximum weight that can be carried in the Parent Tray is 3 lbs. Excessive weight may cause a hazardous unstable condition to exist. * Purses, shopping bags, parcels, diaper bags or accessory items may change the balance of the stroller and cause hazardous unstable conditions. * The maximum weight that can be carried in the basket is 5 lbs. Excessive weight may cause a hazardous unstable condition to exist. * Be certain the stroller is fully erect and latched in the open position before allowing the children near the stroller. * The rear stand on platform is designed for a child who is at least 2 1/2 years old and is not over 40 inches tall. Use of the stroller with two (2) children weighing more than 40 pounds each, or children totaling more than 80 pounds, will cause excessive wear and stress on the stroller and may cause a hazardous unstable condition to exist. * DO NOT use the stroller on stairways or escalators. * Never allow your stroller to be used as a toy * To clean use only mild household soap or detergent and warm water on a sponge or clean cloth. * Check your stroller for loose screws, worn parts, torn material or stitching on a regular basis. Replace or repair parts as needed * Discontinue use of stroller should it malfunction or become damaged. Please contact our customer service Parts Hotline to arrange for repair or obtain replacement parts. Please: If you experience any diffi culty with the use of our product or have a question regarding these instructions, please contact our Customer Service Department at (800) 328-7363 between the hours of 8:00 am and 4:30 pm Pacifi c Coast Time. Please do not return to the store as once it is returned it cannot be resold and the materials and energy used to make it are wasted. To contact us: Baby Trend, Inc. Parts Hotline: 1567 S. Campus Ave. (800) 328-7363 Ontario, CA 91761 8:00 am and 4:30 pm Pacific Coast Time 2 PARTSASSEMBLINGChildTrayFootRestCanopyFrontWheelsStrollerSnap N Go Attachment See Page 8 RearWheelsParent Tray ASSEMBLINGChildTrayFootRestCanopyFrontWheelsStrollerSnap N Go Attachment See Page 8 RearWheelsParent Tray TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE FOLLOW THESE INSTRUCTIONS CAREFULLY. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE ASSEMBLY 1. Remove stroller from box. The front wheels, rear wheels, child tray, and canopy need to be installed prior to use. 2. To attach the front wheels, unfold stroller as described in the section following. See figure 1. Lean the stroller backwards so that it rests on the handle and rear frame tubes and the front wheel tubes are pointing upward. Position the front wheel assembly at the front tube such that the large hole in the swivel assembly will slide onto the front tube. Push each front wheel assembly onto the front tube being careful that wheel assembly locks onto the front leg. Pull on the wheel assembly to ensure that it is securely attached to the stroller. Please see figure 2. 3. Lean the stroller forward to rest on the front wheels. To attach the rear wheels, position the rear axle and wheel assembly such that the brake levers are facing to the rear of the stroller. Press the rear wheel assembly onto the rear frame tubes being careful that the push buttons on the forward side of each rear tube engage the hole on the forward side of each rear wheel housing. Pull on the rear wheel assembly to ensure that it is securely attached to the stroller. Please see figure 3. 4. Ensure that the wheels are firmly locked into place. Do Not use the stroller if the wheels are not locked into place, but rather contact our customer service department immediately at (800) 328-7363, between the hours of 8:00am and 4:30pm PCT, for assistance. 5. Snap footrest onto front legs of stroller just below the seat. Push downward on the footrest until it locks onto the rivets protruding from both sides of each leg and snaps onto the U-shaped frame cross member. Please see figure 4. SnapOnPushDown Fig. 1. Fig. 2. Fig. 3. Fig. 4. 3 6. To attach the front child tray, push the tray onto the front frame tube, lining up the tray between the protruding rivet and the seat. Push backward on the latch until snapped into place. The protruding rivet on the outside Fig. 5. of the frame tube should be above the tray latch. Check that the tray is securely latched in place. Please see figure 5 and 6. 7. To remove front child tray, pull outw...