Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
MODEL # 1638CT Providence Ridge Travel System Instruction Manual 11.06 Convenience through Innovation and thoughtful design WARNINGS WARNING: Please follow all of these instructions to ensure the safety of your child. Keep these instructions for future reference. WARNING: Failure to follow these instructions could result in serious injury or death. Avoid serious injury from falling or sliding out. Always use the seat belt and insure that the child is properly positioned according to these instructions. WARNING: Never leave child unattended. * Purses, shopping bags, parcels, diaper bags or accessory items may change the balance of the stroller and cause hazardous unstable conditions. * The maximum weight that can be carried in the basket is 5 lbs. The maximum weight that can be carried in the Parent Tray is 3 lbs. Excessive weight may cause a hazardous unstable condition to exist. * Be certain the stroller is fully erect and latched in the open position before allowing the child near the stroller. * The maximum weight capacity of this stroller is up to 45 pounds additional weight will cause excessive wear and stress on the stroller and may cause a hazardous unstable condition to exist. * DO NOT use the stroller on stairways or escalators. * Never allow your stroller to be used as a toy * To clean use only mild household soap or detergent and warm water on a sponge or clean cloth. * Check your stroller for loose screws, worn parts, torn material or stitching on a regular basis. Replace or repair parts as needed * Discontinue use of stroller should it malfunction or become damaged. Please contact our customer service Parts Hotline to arrange for repair or obtain replacement parts. Please: If you experience any difficulty with the use of our product or have a question regarding these instructions, please contact our Customer Service Department at (800) 328-7363 between the hours of 8:00 am and 4:30 pm Pacific Coast Time. Please do not return to the store as once it is returned it cannot be resold and the materials and energy used to make it are wasted. To Contact Us: Baby Trend, Inc. Customer Service Hot Line 1567 S. Campus Ave. (800) 328-7363 Ontario, CA 91761 8:00 a.m. to 4:30 p.m. Pacific Standard Time 2 PARTS Child Tray Parent Tray Base Locking Cap CarSeat Rear Wheels FrontWheels Hub Cap Rear Axle Assembly Stroller Front Wheels Solid Cap Car Seat TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE FOLLOW THESE INSTRUCTIONS CAREFULLY. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE. TO ASSEMBLE STROLLER * Remove stroller from box. The front wheels, rear wheels, and child tray, and parent tray need to be installed prior to use. * To attach the front wheels, slide the red unlock mechanism and squeeze the stroller handle while pulling backward on the stroller to unfold. See figures 1 and 2. * Lean the stroller backwards so that it rests on the handle and rear frame tubes and the front wheel tubes are pointing upward. Position the front wheel assembly at the front tube such that the hole in the swivel assembly will slide onto the front tube. Please see figure 3. Push each front wheel assembly onto the front tube being careful that wheel assembly locks onto the front leg. Pull on the wheel assembly to ensure that it is securely attached to the stroller. Please see figure 3. * Lean the stroller forward to rest on the front wheels. Assemble the rear wheels as follows: 1. Slide the rear axle assembly onto the rear stroller legs until they lock into place. Please see figure 4. 2. Slide each wheel onto the rear axle and secure in place with the Locking Cap. Snap the solid cap over the Locking Cap. Snap the Hub Cap onto the wheel. Please see figure 5. Please see figure 6 for order assembly. Pull on each wheel to ensure that each is firmly attached to the axle. * Ensure that the wheels are firmly locked into place. Do Not use the stroller if the wheels are not locked into place, but rather contact our customer service department immediately at (800) 328-7363, between the hours of 8:00am and 4:30pm PCT, for assistance. Figure 1. Figure 2. Figure 3. Figure 4. Figure 5. Figure 6. 3 * To attach the front child tray, push the angled tray onto the post at the end of the right armrest, while pressing downward on the snap button, until locked into place. Please see figure 7. Rotate the tray downward until latched onto the left armrest. Please check that the snap button comes through and securely latches the tray in place. Please see figure 8. * To remove front child tray, press inward on the left side tray release button and rotate upward on the tray. Please see figure 9. Please note that you may remove the tray completely by depressing the snap button on the right side as shown in figure 10 while pulling forward on the tray. Please see figure 7. * To install the canopy slide the male ends of the canopy into the female slots on the stroller frame. Please see figure 11. To open the canopy push forward on the front frame tube of the...