Оценок - , средний балл:
(
)
)
Производитель: Philips
Размер: 277.17 kb
Название файла:
Язык инструкции:
Документ загружается, подождите пожалуйста
 |
Документ загружается, подождите пожалуйста
Фрагмент инструкции
MW: uses a built-in antenna inside the set. Direct the antenna by adjusting the position of your set. SETTING THE CLOCK / ALARM TIME The time is displayed using the 24-hour clock. 1 Hold down SET TIME / ALARM SET. 2 Press HR or MIN repeatedly, or hold down HR or MIN to adjust minute and/or hour. 3 Release SET TIME / ALARM SET and HR or MIN when you reach the correct setting. ™The set clock time will show on the display and start to run. SAFETY INFORMATION • Install the unit near the AC outlet and where the AC power cord plug can be easily reached. • Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnet device shall remain readily operable. • Place the set on a hard and flat surface so that the system does not tilt. • If you do not intend to use the set for a long time, withdraw the power plug from the wall outlet. In addition to this, it is advisable to remove the battery from the clock radio. This will prevent any danger of leakage and the clock radio will not be damaged. • Do not expose the set, batteries to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. • The apparatus shall not be exposed to dripping or splashing. • Adequate ventilation with a minimum gap of 15cm between the ventilation holes and surrounding surfaces is necessary to prevent heat build-up. • The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc.. • No objects filled with liquids, such as vases, shall be placed on the appartus. • No naked flame sources, such as lighted candles, should be placed on the apparatus. • To clean the set, use a soft, slightly dampened chamois leather. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing. CAUTION -High voltage! Do not open.You run the risk of getting an electric shock. The machine does not contain any user-serviceable parts. -Modification of the product could result in hazardous radiation of EMC or other unsafe operation. This set complies with the radio interference requirements of the European Union. SELECTING THE ALARM MODE To use the alarm, you must set the alarm time first. You can choose from two different alarm modes to wake you up: by radio or buzzer. 1 Select your choice of alarm mode by adjusting RADIO / ALARM to RADIO or BUZZER. ™The alarm indicator (AL) will light up. Helpful Hint: • If you have selected the radio mode, make sure you have adjusted the volume loud enough to wake you. • The buzzer is set at a fixed volume and cannot be adjusted. SWITCHING OFF THE ALARM There are three ways of switching off the alarm. Unless you cancel the alarm completely, the 24 hour alarm reset option will be automatically selected after 1 hour and 59 minutes, from the time your alarm time first goes off. 24 HOUR ALARM RESET If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day: • Press ALARM RESET during the alarm call. ™The alarm indicator (AL) will remain on. CANCELING THE ALARM COMPLETELY To cancel the set alarm time before it goes off, or during the alarm call: • Adjust RADIO / ALARM to OFF position. ™The alarm indicator (AL) will light off. TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty. Do not open the set as there is a risk of electric shock. Problem – Possible Cause • Remedy No sound/power – Volume not adjusted • Adjust the volume Occasional crackling sound during FM broadcast – Weak signal • Adjust the position of the Pigtail Continuous crackling/hiss disturbance during MW broadcast – Electrical interference from TV, computer, fluorescent lamp, etc. • Move set away from other electrical equipment The alarm does not function – Alarm time not set and or alarm mode not selected •Set the alarm time and / select alarm mode – Volume too low for RADIO • Adjust the volume – Radio alarm not adjusted to radio station •Tune to a radio station REPEAT ALARM This repeats your alarm call at 9-minute intervals. 1 During the alarm call, press REPEAT ALARM. 2 Repeat if desired for up to 59 minutes. ™ The alarm indicator (AL) will remain on. SLEEP This set has a built-in timer which enables the set to be automatically switched off during radio playback after a set period of time. This allows you to lie back, listen and fall asleep. The maximum sleep time is 1 hour and 59 minutes. Setting SLEEP 1 Set RADIO / ALARM to OFF position. 2 Set the sleep time to activate sleep function by selecting on the following ways: • Simply press SLEEP to set your sleep time to 59 minutes. • Hold down SLEEP, and press MIN repeatedly to adjust sleep time from 59 minutes downward. • ...