Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
If you have any questions or
WARNING
Precautions
problems concerning your player,
please consult your nearest Sony
To prevent fire or shock
On safety
dealer.
hazard, do not expose the unit
• Caution — The use of optical
instruments with this product will
to rain or moisture.
increase eye hazard.
To avoid electrical shock, do
• Should any solid object or liquid fall
not open the cabinet. Refer
into the cabinet, unplug the player and
servicing to qualified
have it checked by qualified personnel
before operating it any further.
personnel only.
On power souces
The laser component in this product
• Before operating the player, check that
is capable of emitting radiation
the operating voltage of the player is
exceeding the limit for Class 1.
identical with your local power
supply. The operating voltage is
indicated on the nameplate at the rear
of the player.
• The player is not disconnected from
the Mains as long as it is connected to
the wall outlet, even if the player itself
has been turned off.
• If you are not going to use the player
for a long time, be sure to disconnect
This appliance is classified as a CLASS 1
the player from the wall outlet. To
LASER product. The CLASS 1 LASER
disconnect the mains lead, grasp the
PRODUCT MARKING is located on the
plug itself; never pull the cord.
rear exterior.
• Mains lead must be changed only at a
qualified service shop.
The following caution label is located
inside of the unit.
On placement
• Place the player in a location with
adequate ventilation to prevent heat
build-up in the player.
• Do not place the player on a soft
surface such as a rug that might block
the ventilation holes on the bottom.
• Do not place the player in a location
near heat sources, or in a place subject
For the customers in Canada
to direct sunlight, excessive dust or
CAUTION
mechanical shock.
TO PREVENT ELECTRIC SHOCK,
On operation
DO NOT USE THIS POLARIZED AC
• If the player is brought directly from a
PLUG WITH AN EXTENSION
cold to a warm location, or is placed in
CORD, RECEPTACLE OR OTHER
a very damp room, moisture may
OUTLET UNLESS THE BLADES
condense on the lenses inside the
CAN BE FULLY INSERTED TO
player. Should this occur, the player
PREVENT BLADE EXPOSURE.
may not operate properly. In this case,
remove the disc and leave the player
turned on for about an hour until the
moisture evaporates.
On cleaning
• Clean the cabinet, panel and controls
with a soft cloth slightly moistened
with a mild detergent solution. Do not
use any type of abrasive pad, scouring
powder or solvent such as alcohol or
benzine.
2EN
...