Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
– selects the next/previous track – fast searches forwards/backwards (press and hold the button) PROG – programs tracks 9 – stops CD playback; – erases a CD program 3 Display – shows the CD functions 4 MODE – selects different play modes: e.g. REPEAT or SHUFFLE (random order) 5 ALBUM + – For MP3-CD only: selects albums 6 OPEN•CLOSE – opens/ closes the CD door 7 TUNING – tunes to radio stations 8 VOLUME – adjusts volume level Back/bottom panels (See 1) 9 Telescopic antenna – improves FM reception 0 Battery door – open to inser t 6 x 1.5V R-14/ UM-2/ C-cells ! p – 3.5 mm stereo headphone socket Helpful hints: The speakers will be muted when headphones are connected to the set. @ AC MAINS~ – inlet for power cord CAUTION Use of controls or adjustments or performance of procedures other than herein may result in unsafe operation. Power Supply Whenever convenient, use the power supply cord if you want to conser ve battery life. Make sure you remove the plug from the set and wall outlet before inser ting batteries. Batteries (not included) 1 Open the batter y door and inser t 6 batteries, type R-14, UM-2 or C-cells, (preferably alkaline) with the correct polarity as indicated by the "+" and "–" symbols inside the compar tment (See 1). 2 Replace the battery door, making sure the batteries are firmly and correctly in place.The set is now ready to operate. Power Supply Basic Operation/ Radio • Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst: • Do not mix batter y types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set. • When inserting new batteries, do not tr y to mix old batteries with the new ones. • Remove the batteries if the set is not to be used for a long time. Batteries contain chemical substances, so they should be disposed of properly. Using AC power 1 Check if the power voltage, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center. 2 Connect the power cord to the AC MAINS~ inlet and the wall socket. The set is now connected and ready for use. 3 To switch the set off completely, withdraw the power cord from the wall socket. 4 Install the unit near the AC outlet and where the AC power plug can be easily reached. • Disconnect the power cord from the wall socket to protect your set during heavy thunderstorms. Children could seriously injure themselves as the free end of the cable may still be live if only the connector is removed from the MAINS socket at the back of the unit. The type plate is located on the bottom of the set. Helpful hints: – To avoid unnecessar y energy consumption, always adjust the Source selector to OFF after using the set. Basic operation Switching on and off and selecting the function 1 To select your sound source, adjust the Source selector to: CD/MP3, FM, or MW. 2 To switch off the set, adjust the Source selector to OFF position. Adjusting volume Adjust the sound with the VOLUME control. Radio reception 1 Adjust the Source selector to FM or MW to select your desired waveband. 2 Turn TUNING to tune to a station. Helpful hints: To improve radio reception • For FM, extend, incline and turn the telescopic antenna for best reception. Reduce its length if the signal is too strong. • For MW, the set uses a built-in antenna. Direct this antenna for best reception by turning the whole set. CD/MP3 Player About MP3 The music compression technology MP3 (MPEG1 Audio Layer 3) significantly reduce the digital data of an audio CD while maintaining CD quality sound. • Getting MP3 files: you can either download legal music files from the internet to your computer hard disc, or create such files by conver ting audio CD files in your computer through appropriate encoder software. (128kbps bit rate or higher is recommended for MP3 files.) • Creating a MP3 CD: burn the music files from your computer hard disc on a CDR or CDRW using your CD burner. Helpful hints: – Make sure that the file names of the MP3 files end with .mp3. – Number of albums: maximum 99 – Number of tracks: maximum 400 – The length of file names affects the number of tracks for playback. With shorter file names, more files can be burned on a disc. Playing a disc This player plays Audio Discs including CD-R/ CD-RW, MP3 CD. Do not try to play a CDROM, CD-I, CDV, VCD, DVD or computer CD. IMPORTANT! • CDs encoded with copyright protection technologies by some record companies may be unplayable by this product. 1 Adjust the Source selector to CD/MP3. 2 Open the CD door. 3 Inser t a CD with the printed side facing up, then press the CD door gently to close. . Display shows ---, and later the total number of tracks. 4 Press 2; to star t playback. 5 To pause playback, press 2;. . Display: 2 and the current track number flash (See 2). 6 To resume, press 2; again. 7 To stop playback, press 9. Helpful hints: CD play will also stop when: – you op...