Оценок - 1, средний балл: 4
(
)
)
|
Фрагмент инструкции
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. Canadian Notice (Avis Canadien) Class B Equipment This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. Cet appareil numerique de la classe B respecte toutes les exigences du Reglement sur le materiel brouilleur du Canada. This products complies with the EMC Directive (89/336/EEC) and the Low Voltage Directive (73/23/EEC) issued by the Commission of the European Community. Compliance with these directives implies conformity to the following European Norms (in parentheses are the equivalent international standards and regulations): o EN55022 (CISPR 22) - Electromagnetic Interference o EN55024 (IEC61000-4-2, 3, 4, 5, 6, 8, 11) - Electromagnetic Immunity o EN61000-3-2 (IEC61000-3-2) - Power Line Harmonics o EN61000-3-3 (IEC61000-3-3) - Power Line Flicker o EN60950 (IEC60950) - Product Safety Laser Safety This CD player has been designed and manufactured according to FDA regulations "title 21,CFR, chapter 1, subchapter J, based on the Radiation Control for Health and Safety Act of 1968", and is classified as a Class 1 laser product. CLASS 1 LASER PRODUCT No User Serviceable Components Inside. For service, contact your Authorised Dealer or Distributor. Any modifications to this equipment will void all warranties . DANGER - invisible laser radiation when opened and interlock failed or defeated. Avoid direct exposure to beam. CAUTION - use of all controls, adjustment or performance of procedures other than specified herein may result in hazardous radiation exposure. WARNINGS The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying this component. ! This component weighs over 35 kilograms. Do not place this component on an unstable cart, stand, tripod, bracket or table as the component may fall causing serious injury to a child or adult and serious damage to the unit. An appliance and cart combination should be moved with care. Quick stops, excessive force and uneven surfaces may cause the component and cart combination to overturn. Any mounting of the device on a wall or ceiling should follow the manufacturer’s instructions and should use a mounting accessory recommended by the manufacturer. Read and follow all the safety and operating instructions before connecting or using this component. All warnings on the component and in its operating instructions should be adhered to. Retain this Owner’s Manual for future reference. Do not use this unit near water; for example, near a bath tub, washbowl, kitchen sink, laundry tub, in a wet basement or near a swimming pool. Unplug the component from the wall outlet before cleaning. Never use benzine, thinner or other solvents for cleaning; use only a soft damp cloth. This component should be serviced only by qualified AMR service personnel when: A. The power cable or the power input socket has been damaged; B. Objects have fallen, or liquid has been spilled into the component; C. The component has been exposed to rain or liquids of any kind; D. The component does not appear to operate normally or exhibits a marked change in performance; E. The component has been dropped or the enclosure has been damaged. DO NOT ATTEMPT SERVICING OF THIS UNIT-YOURSELF. REFER SERVICING TO QUALIFIED AMR SERVICE PERSONNEL Upon completion of any servicing or repairs, request the service point’s assurance that only AMR Authorised Replacement Parts with the same...