Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
Depending on the application, connect the Black/Green wire to the ground tab on the back of the factory radio chassis or splice wire to Pin #11 of the vehicle side J1 connector. 9. Either by splicing or using the T-tap provided, connect the Grey/Purple wire from the CDC-FDN to Pin #9 wire of the vehicle side J1 connector. OPERATION CHECK: 1. Load CD’s into the CD Changer cartridge and insert the cartridge into the changer. 2. Start vehicle and allow CD Changer to cycle. Perform a brief functional test to verify proper operation according to the owner’s manual. © 1998 Audiovox Corporation, 150 Marcus Blvd., Hauppauge, N.Y. 11788 . Printed in China CDC-FDW Installation Diagram (Fig. 1) 6 OR 10 DISC CHANGER CD CHANGER DATA CONNECTOR 8-PIN DIN CONNECTOR VEHICLE CD CHANGER DATA CONNECTOR (LOCATED IN TRUNK) CDC-FDW CDC-FDN Installation Diagram (Fig. 2) J3 VEHICLE CD CHANGER CONNECTOR FACTORY RADIO REAR VIEW 6 OR 10 DISC CHANGER J3 CD CHANGER DATA CONNECTOR J1 VEHICLE POWER/SPEAKER CONNECTOR (SEE J1 CONNECTOR DETAIL) POWER /SPEAKER CONNECTOR GRAY/PURPLE WIRE CONSTANT 12 VOLTS .25" FEMALE SPADE TERMINAL GROUND TERMINAL (See Note) BLACK w/GREEN STRIPE GROUND WIRE T-TAP OR SPLICE ONTO WIRE AT PIN-9 LOCATION .25" MALE SPADE TERMINAL PROVIDED IN KIT FACE VIEW OF CONNECTOR PIN FUNCTION 1 ILLUMINATION (+) 2 ILLUMINATION (-) 3 START (MUTE FOR CRANK) 4 CLOCK SET 5 RIGHT REAR (+) 6 RIGHT REAR (-) 7 RIGHT FRONT (+) 8 RIGHT FRONT (-) 9 + 12VDC BATTERY MEMORY 10 + 12VDC BATTERY ACC 11 CHASSIS GROUND 12 LEFT REAR (+) 13 LEFT REAR (-) 14 LEFT FRONT (+) 15 LEFT FRONT (-) 16 POWER AMP GROUND J1 CONNECTOR DETAIL 18 916 PIN-9 WIRE COLOR WILL VARY WITH VEHICLE. CDC-FDN NOTE: For vehicles without ground terminal, splice Black w/Green stripe wire into Pin #11 of the vehicle side J1 connector. ...
Эта инструкция также подходит к моделям:CD-проигрыватели - CDC-FDN (55.02 kb)