Оценок - 5, средний балл: 3.8 ( )

Производитель: Clarion Размер: 418.34 kb Название файла: DCZ625.pdf Язык инструкции:

Clean the disc. 1. Referring to section “INSTALLATION”, check the three angle of installation selector levers are properly set. If not, set them at the proper position for the angle of installation. 2. Check whether The CD magazine can be ejected by pressing the CD magazine eject button, then insert a new CD magazine. Read the section on “Inserting the CD” carefully and reinsert the disc holder correctly. lf the same phenomenon still occurs after checking the above, or it is impossible to remove the magazine, please consult your local dealer. 10 SPECIFICATIONS Clarion Co.,Ltd. All right Reserved. Copyright © 2001:Clarion Co., Ltd. 6-Disc Capability CeNET with Balanced Audio Line Transmission and Dynamic Noise Canceling 8-Times Oversampling Digital Filter Dual 1-Bit D/A Converters Zero-Bit Detector™ Mute Circuit 3-Beam Laser System Spring-Loaded Silicon Oil-Dampened Suspension System Eject Capability While lgnition-Off 120° Mounting Capability Optical Digital Output CD TEXT Dimensions: 8-7/8"(225mm)W . 2-1/"2(63mm)H . 6-9/16"(167mm)D • The unit may not operate when both CD changers are set to the same address switch number. • Never change the address switch during operation. Doing so can cause malfunction or breakdown. Do not change the address switch forcibly, because this may also cause malfunciton. This unit is available for upgrade in various ways. When you want to upgrade the system, make sure that the upgrade unit fits and wire it correctly. 8 INSTALLATION Prior to Installation 1. Before attempting to use this unit you must first remove the packing safety lock pins (3 positions). Store these lock pins carefully so they can be used again if needed. Note: • Reinstall these lock pins when shipping the unit back for repair. English Frequency Response : 5Hz~20kHz(±1dB) Signal-to-Noise Ratio : 105dB(1kHz)IHF•A Wow and Flutter : Below measurement limits Power Supply : DC14.4V (10.8~15.6V) negative ground Current Consumption : Less than 1A Unit Weight : 3.6lb. (1.65kg) Dimensions : 8-7/8"(Width) . 2-1/2" (Height) . 6-9/16"(Depth) [225mm(W) . 63mm(H) . 167mm(D)] .Due to improvements, the design and these specifications may be modified without prior notice. Caution 3 CAUTIONS ON HANDLING CDs The following magazines cannot be used for this unit. Using them will result in a damage to the mechanism and cause the magazine not to eject. • magazine (CAA-122) for the 12-disc CD changer (CDR1255z, CDR1240Z, CDC1235, etc.) • magazine (CAA-355) for the 6-disc CD changer (CDR655Tz, CDR655z, CDR640Z, etc.) Caution Setting example 2 CD changer CD changer Address switch number 1 Address switch number 2 Important Be sure that the CD changer numbers are not the same. Source unit CD changer MD changer Address switch number 1 Do not use the address switch numbers “3” and “4” for the MD changer. Address switch number 1 Setting example 1 CeNET wire bound CeNET wire bound Source unit Important 1 2 1 1 7 INSTALLATION OF CONNECTORS Caution Note: Only the provided screws and brackets should be used during installation. Using screws other than those specified will cause damage. • When connecting the CeNET cable, fully insert it. After connection, fix the connector with a clamper as shown in the figure. • When removing the digital optical fiber cable, rotate it to loosen it and pull it gently while holding the slide cap (a gray color part on the source unit). • Do not coil up the digital optical fiber cable with a radius of less than 1" (3 cm). With a radius of less than 1", the performance of the cable will be greatly impaired. • When installed in a glove box or console box, make sure that the source unit cables or cords do not interfere with the opening or closing of the flip down door. 5 CD MAGAZINE Inserting the CD Caution • Pulling strongly on the disc holder may cause it to come out of the magazine. In such cases, press in on the disc holder tabs and re-insert into the magazine. Be sure that the disc holder is correctly inserted. Magazine Disc Holder Caution Handling New discs may have some roughness around the edge. The set may not work or the sound may skip if such discs are used. Use a ball-point pen, etc., to remove roughness from the edge of the disc. Ball-point pen Roughness Never stick labels on the surface of the compact disc or mark the surface with a pencil or pen. Never play a compact disc with any cellophane tape or other glue on it or with peeling off marks. If you try to play such a compact disc, you may not be able to get it back out of the CD player or it may damage the CD player. Always handle the compact disc by the edges. Never touch the surface. • Look through the magazine opening and check whether or not the CD is tilted. If the disc holder does not slide in fully, or slides with difficulty, it is possible that the CD is not correctly loaded. Reload in such cases. This equipment has been tested and found to comply with the limits for a Class B digital device...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: