Оценок - 4, средний балл: 4.8
(
)
)
|
Фрагмент инструкции
Slide the POWER Switch to the ON position. And Slide the FUNCTION Switch to the TAPE position. Press the cassette Play ( ) Button to begin playback. Adjust the VOLUME 1 2 Insert a pre-recorded cassette into the slots in the Cassette Door with the open end facing up and the full reel on the right side. Close the cassette door. To stop playback before the tape ends, press the Stop/Eject ( ) Button. The Play Button is release and the tape motor shuts off. Press the STOP/EJECT ( ) Button to open the Cassette Door. When the tape reachs the end, the auto-stop mechanism activates, the tape PLAY Button is release and the tape motor shuts off. Press the Stop/Eject ( ) Button to open the Cassette Door and remove the tape. To advance or rewind the tape rapidly, press either the cassette Fast Forward ( ) or Rewind ( ) button. When you reach the desired point, press the cassette play ( ) Button to resume normal playback. 1 3 2 -12- -13- When you are ready to begin recording, press the cassette Record ( ) Button. The cassette Play ( ) Button will also engage. The tape will begin moving and all of the material from your selected source will be recorded on the tape. 1 2 8 3 9 To avoid recording unwanted material, such as radio commercials, use the Pause ( ) Button to stop the recording temporarily . Release the Pause ( ) Button to begin recording again. Select the function you wish to record, either radio or CD, and operate that function according to its own instructions. Open the Cassette Door and insert a good quality blank cassette tape into the slots on the door, with the open end facing up and the full reel on the righthand side. Close the Cassette Door When you are finished recording press the Stop/Eject( ) Button to stop the tape. MAKING A TAPE RECORDING The tape recorder in this system allows you to make direct recordings from the radio or CD player to a blank cassette in the tape compartment. An automatic recording volume level control (ALC) circuit will automatically control the volume level of your recordings to prevent distortion. You may change the settings of the volume during a tape recording, as these controls have no effect on the material being recorded onto the tape. To make a tape recording, proceed as follows: If you wish to listen to your recording immediately, press the cassette Rewind ( ) Button until the tape rewinds to the beginning, then press the Stop/Eject ( ) Button . Set the FUNCTION Switch to the TAPE position and press the cassette Play ( ) Button to begin playback. 1 2 3 4 Open surface side Emptiest reel 7 2 21 24 3 Dynamic Bass Boost System (DBBS) This special circuit provides bass response, especially at lower volume levels where the bass has a tendency to disappear. Set the DBBS button to On to increase the bass. Set the DBBS button to Off for normal bass response. Note: If you have the DBBS circuit On at high volume and you are listening to music that contains very strong bass, you may experience some distortion. If this occurs, reduce the volume or switch the DBBS button Off . , , , , , , Tab for side 2 Tab for side 1 Tab Break out the tab Cover with tape CARE AND MAINTENANCE SAFEGUARD AGAINST ACCIDENTAL ERASURE When a new recording is make, any program material previously recorded is automatically erased and only the new recording remains. To safeguard valuable recordings from being erased accidentally, the cassette and the deck are equipped with a spacial device. On the back of the cassette there is an erase prevention tab on each side. To prevent accidental erasing, break out these tabs wish a screwdriver. If only one side of the tape is to be protected break out the tab on the left side with the side desired facing you. To record on a tape in which the tab has been broken, place a place of adhesive tape over that area. NOTE: When a tab is broken out, the record button cannot be depressed. CASSETTE TAPE RECOMMENDATIONS Standard tape lengths have 15 (C-30),30 (C-60) and 45 (C-90) minutes of recording time on each side. Longer length tapes of 60 (C-120) minutes of recording time on each side are not recommended. Use only high quality tapes. If a problem develops, check the unit first with another cassette to determine if the problem is with the cassette, and not with the unit. If there is any stack in the tape in the cassette, it should be removed before inserting the cassette. Place a pencil in one of the hubs and rotate toward the outside of the cassette until all stack is taken up. -14- -15- CARRE AANND MMAINTEENAANCE TTRROOUUBBLLEESSHHOOOOTTIINNGG GGUUIIDDEE Caring for Compact Discs Should this unit exhibit a problem, check the following before seeking service. * Treat the disc carefully. Handle the disc only by its edges. Never allow your fingers to come in contact with the shiny, unprinted side of the disc. * Do not attach adhesive tape, stickers, etc. To the disc label. * Clean the disc periodically with a soft , lint-free, dry cloth. Never use detergents or abrasive cleaners ...