Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
We suggest that after reading it you keep this manual in a safe place for future reference. ESN E5 High-Power "Full-Face" CD Receiver with MP3 Decoder CD5425 For your safety in using the CD5425 Warnings and caution signs, illustrated below, are posted throughout this manual as well as on the CD5425. They show safe and correct ways to handle the product so as to prevent personal injury to you, others and to avoid property damage. Before reading through the manual, take time to read through and learn the important information listed in this section. This sign indicates a situation in which incorrect Warning handling or disregard of this sign might result in death or serious personal injury. This sign indicates a situation in which incorrect handling or disregard of this sign might result in Caution personal injury or may result solely in damage to property. Warning . Do not modify this system for use other than that specified herein. Also, do not deviate from the installation procedures described herein; Eclipse will not be held liable for damages including, but not limited to serious injury, death or property damage resulting from installations that enable unintended operation. . This equipment requires 12V DC and should only be installed in a vehicle with a 12V negative ground electrical system. Any other installation may cause a fire or other severe damage to the equipment and the vehicle. . Never install this equipment where it will interfere with safe operation of the vehicle. Never block the drivers’ view. Do not install equipment where it may interfere with operation of the brakes, the steering or any safety equipment, including seat belts and air bags. 2 Warning . Before drilling holes in a vehicle for installation, you must confirm the locations of pipes, tanks, electrical wiring, and other vehicle systems and components to ensure that there will be no interference or contact. In addition, you must also apply rust prevention and leak prevention measures at the drilling area. Otherwise, fire or electric shock could occur. . When installing equipment do not remove or alter existing vehicle fasteners, including nuts, bolts, screws, clips, and fittings. Never detach, move or alter existing vehicle wiring, including electrical grounds and straps. Alteration of existing vehicle components may make vehicle unsafe to operate. . Before installation, remove the negative (-) battery terminal to prevent shocks, electrical arcing, fires, and damage to vehicle wiring and the equipment you are installing. . Secure wiring with tape or plastic ties so that wires do not interfere with vehicle operation, including brake pedal, gear shifter and steering. Position wires so that they will not be rubbed, abraded, or damaged by moving vehicle components, including power seats. . To avoid equipment and vehicle damage, including fire, never supply power to installed equipment in a way which will overload the capacity of an existing vehicle circuit. Never leave a power supply wire or connection uninsulated. Always install supplied fuses, circuit breakers, and relays. . Air bags are vital safety equipment. Never install equipment in a way which will alter air bag wiring or interfere with air bag deployment. Air bags must function properly in the event of an accident. . When installation is complete, test all vehicle electrical systems for proper operation, including lights, horn, brake lights, and emergency flashers. . For your protection, never use a power drill without safety glasses or goggles. Debris or broken drill bits may cause severe eye injuries, including blindness. . Use electrical tape to insulate the ends of all wires, even if not used. Proper insulation prevents arcs, shocks and fires. 3 Warning . Some equipment uses batteries. Never install equipment where young children can get access to batteries. If a battery is swallowed, seek medical attention immediately. . When vehicle is moving, never take your eyes off the road to make adjustments to the equipment. You must pay attention to the road to avoid accidents, do not let the operation or adjustment of the equipment distract you from proper vehicle operation. . The driver should not look at the screen while driving. Accidents may result if you are not paying attention to the forward direction. . Do not put foreign objects in the loading slot of disk. Fires or shocks may result. . Do not disassemble or alter this equipment. Accidents, fires or shocks may result. . Do not let water or foreign objects enter the internal parts of this equipment. Smoke, fires or shocks may result. . Pay attention to where the remote control is left. Traffic accidents or problems with driving may result if the remote control makes its way under the foot pedals etc. when the vehicle is stopped or when it goes around a corner. . Do not use when it is broken (the screen is not lit or no sound comes out). Accidents, fires or shocks may result. . Always replace fuses with fuses of identical...