To use screws other than M3 X 6 may result in malfuction. ■/. Make sure that the PC is powered off and disconnected from any power source. 2. If necessary, attach a horizontal bracket to both sides of the drive. 3. Remove the cover from a free expansion slot and install the COMBO drive, as shown in the illustration. SAMSUNG DIGIТай) everyone’s invite If there is two Optical drive, select MA (Master) / SL (Slave). / a : Master Drive (Choose the MA Jumper) b : Slave Drive (Choose the SL Jumper) c : Hard Drive d : MainBoard e : Primary 1 f : Secondly 1 3. Installing a jumper on the master/slave select terminal V Connect a jumper to the rear side of the COMBO. If the jumper is connected to MA (Master), it will work in the Master mode. If the jumper is connected to SL (Slave), it will work in the Slave mode. If the jumper is connected to CS (CSEL), you can control the device by using the host interface signal CSEL. (In general, connection to MA is recommended.) SAMSUNG DIGIТай) everyone’s invite Connect the 4-pin audio cable between the sound output terminal on the Optical drive and the audio input terminal on the sound card. > For clearer sound, use a digital output terminal.(Available only for the CARD that supports digital output) This may not be available for general sound cards. SAMSUNG DIGIТай) everyone’s invite Automatic Setup The device driver is located in the Ddriver folder of the CD Record Utility disc which is provided in the package. i . Insert the CD Record Utility disc into the CD-ROM drive and open the Ddriver folder. 2. Run the CDSETUP.EXE file in the Ddriver folder. 3. When Setup is successfully completed, click OK button or press the Enter key. 4 . Reboot the computer. > Manual Setup 1. Make the C:\SAMSUNG directory. 2. Copy the files from the diskette to the C:\SAMSUNG directory. To do so, type COPY D:\Ddriver * . * C:\SAMSUNG after the C:\prompt and press [Enter]. 3 Edit the CONFIG.SYS file. ' Add the DEVICE=C:\SAMSUNG\SSCDROM.SYS \D:SSCD000/V entry. *c sivtsnocssninoM syst> : stem» v 4 Edit the AUTOEXEC.BAT file. ' Add the C:\SAMSUNG\MSCDEX/D:SSCD000 entry. C SAVSIMOMWMX t)S4KOO 5. Reboot the computer. SAMSUNG DIGIТай) everyone’s inviteЭта инструкция также подходит к моделям: CD/DVD приводы - TS-H492C (560.67 kb)
