Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
1 1 Turn OFF your computer. Remember to verify the configuration jumper on the rear of the CD-ROM drive. 2 2 Remove the cover of your PC. (main unit of the computer) 3 3 Remove the blank cover panel of the 5.25 inch unit in which the CD-ROM drive is to be installed. 4 4 Connect the CD-ROM drive to the IDE interface and power cables Iocated inside your computer. . Connectors are keyed so it is impossible to put them in an incorrect position. Do not force the connectors, if they do not seem to fit. 5 5 Install the CD-ROM drive into the unit and secure it with mounting screws. (recommended standard M3x6x4) * u Depending on your PC model, you may need to attach guide rails to the drive, so that the drive is held firmly in place. . If you use screws that are longer than the recommended standard, you may damage the drive. 6 6 Put the cover back on your PC. Installing the You can install the device driver for DOS or for Windows. . Do not install DOS Driver when the program of Windows 95/98 is going on . (Remark CD-ROM Driver in the state of CONFIG. SYS. ) 1 Turn on your computer and wait for it to boot. Insert the driver disk into a floppy disk drive(usually 2 If you are a.. . Then : 3 DOS user . Type a: at the DOS prompt . Press the RETURN key Windows user . Access the File Manager u Click on the A icon. Windows 95/98 user u When you are in Windows 95/98, it is not necessary to install Device Driver. Whereas, when you are in Dos Mode of Windows 95/98, then install as follows. . Click on MY COMPUTER icon. . Click on the A icon. Run the CDSETUP program: 4 If you are a... Then : DOS user u Type CDSETUP after the A: prompt u Press RETURN Windows user Double-click CDSETUP.EXE from the Windows File Manager To.. . Then enter... 5 Confirm the installation Y Exit without installing N Result : If you answer Y(Yes), the installation program automatically . Creates a SAMSUNG directory on your hard disk . Copies the required softwares (mscdex.exe and sscdrom.sys) . Modifies the CONFIG.SYS and AUTOEXEC.BAT files When the Setup Completed screen is displayed, remove the installation 6 floppy disk from the drive. Reboot your system. 7 Result : u The computer restarts u Both the device driver and MSCDEX are loaded 4 5 Resolving Technical Problems Technical Specifications * Please consult the following table representative. Proble m Meaning / Solution The software installation failed u Check that your hard disk is not full. . The installation floppy disk may be corrupted. Repeat the installation with the backup floppy disk. I re-booted my PC and it paused After installing the device driver, your system during the start-up program. start-up program may take more time than expected. If it does not start-up after 60 seconds, verify your AUTOEXEC. BAT file and, if necessary, contact your local computer dealer. The disc tray does not open. The drive may not be installed correctly. Verify the physical installation. In the File Manager, the CD-ROM icon does not display. I insta...
Эта инструкция также подходит к моделям:CD/DVD приводы - SC-140B (150.39 kb)
CD/DVD приводы - SC-148E (150.39 kb)