Оценок - 2, средний балл: 3
(
)
)
|
Фрагмент инструкции
18) 7 Basic operations for playback (.. 14 – 16) 8 Show Status messages (.. 17) 9 Show Top Menu/Direct Navigator (.. 14) 10 Show the Sub Menu 11 Use according to the instructions on the screen 12 Playback as a Photo Frame (.. 20) 13 Switch the display mode of Photo Frame (.. 20) 14 Switch the drive to playback (.. 8) 15 Change the Setup of this unit (.. 36) 16 Change the screen settings (.. 12) 17 Turn the unit off automatically (.. 11) 18 Adjust the volume (.. 14) 19 Mute the sound Press again to clear 20 Switch on/off Secondary Audio (.. 18) 21 Exit the menu screen 22 Show Pop-up Menu (.. 14) 23 Show FUNCTION MENU (.. 12) 24 Selection/OK, Frame-by-frame 25 Return to previous screen 26 Select audio (.. 17) 27 Switch the display design of Photo Frame (.. 20) . Insert the batteries (included) Insert so the poles (i and j) match those in the remote control. . After inserting the batteries, close the cover so it is as it was by inserting the s (minus) side first. . Range of use The distance and angles are approximate. Remote control .. 24 20 25 27 26 18 14 17 21 22 23 19 16 1 15 3 6 7 5 4 11 12 8 10 9 2 13 . To select: Press up, down, left, or right ([3, 4, 2, 1]) . To enter: Press [OK] . Frame forward / Frame backward: (While paused) press left or right ([2;][;1]) R6/LR6, AA (Alkaline or manganese batteries) 1 2 Remote control signal sensor Within 30 degrees angle either left or right Within 20 degrees angle either up or down Remote control transmitter Within 7 m (23 ft.) in front Installation of the unit Open the stand and set the unit on a horizontal and stable level surface. .Use the stand in a fully opened state. .The unit cannot be mounted in the car. .The unit does not have magnetic shielding. Do not place the unit near televisions, personal computers or other devices easily influenced by magnetism. Do not keep this unit and magnetized cards (bank cards, commuter passes, etc.) close together. When holding the unit: .Hold the unit with the stand closed. When moving the unit: .Turn the unit off. .Close the screen and the stand. About the LCD screen There may be 0.01 % or less chance of missing or constantly turned on pixels, but this is not a malfunction. Caution .Do not place with the LCD screen down. Doing so may scratch the surface of the LCD screen. .Do not insert a finger between the main unit and the stand when installing or moving this unit. Doing so may result in fingers getting caught between the unit and the stand and cause injuries. Especially keep an eye on children. DO NOT Preparing the Power Supply Using the unit connected to the AC adaptor AC adaptor (included) To a household AC outlet AC power supply cord (included) 123 The unit is in the standby condition (the [CHARGE] indicator lights) when the AC power supply cord is connected. The primary circuit is always “live” as long as the AC adaptor is connected to an electrical outlet. To conserve power This unit consumes 0.4 W (Approximately 5 W when Quick Start is set to “On”) of power even when turned off. When the unit is not going to be used for a long time, disconnect the AC power supply cord from the household AC outlet. Using the battery pack This unit can be used in places without an AC outlet, such as outdoors, by attaching the included battery pack. .The battery is not charged at the time of purchase. Charge before initial use. .The battery is designed only for use with this unit. It cannot be used with other equipment. . Attaching the battery pack Turn the unit off before attaching or detaching the battery pack. .Attach the battery pack after you open the stand. Bottom side of this unit RELEASE DETACH ATTACH RELEASE DETACH ATTACH . Battery pack (included) . 1 Bring in from the left, aligning the grooves. 2 Slide all the way to the right until you hear a "click". Check to make sure it is securely fastened. VQT2J81 (ENG) . Detaching the battery pack Bottom side of this unit 2 Slide. RELEASEDETACHATTACH 1 Press and hold. When not using for long periods of time .Detach the battery pack (• above). (Even when the unit is turned off, there is a small amount of voltage running through the unit, and this may result in a malfunction.) .Recharge the battery for re-use. . Recharging the battery pack Attach the battery pack and connect the AC adaptor (• 10). .The [CHARGE] indicator lights while charging the battery, and the [CHARGE] indicator turns off when battery charging is finished. [CHARGE] indicator (Orange light) . Approximate recharging and play times (Hours) Battery pack Recharging*1 Play*2 LCD brightness level j5 0 i5 DY-DB30 (included/ optional) 5 3.5 3 2.75 DY-DB15 (optional) 4 2.75 2.5 2.25 DY-DB100 (optional) 7.5 5.5 5 4.5 *1 When the unit is off [at 20 oC (68 oF)] *2 At room temperature using headphones [at 20 oC (68 oF)] .Play time indicated above may differ depending on the use. .To change the LCD brightness (• 12, “Adjusting the pictures on the LCD screen”). . Checking the remaining battery charge Not displayed when the AC adapt...
Эта инструкция также подходит к моделям:Blu-Ray проигрыватели - DMP-B500 (4.72 mb)