Оценок - 5, средний балл: 3.6
(
)
)
|
Фрагмент инструкции
Figure 4.. Illustration Legend. T10050 Right angle iron Bender 3.. Thread the work stop knob into the work stop, Assembly then slide the work stop onto the work stop rod (Figure 7). The Model T10050 requires only minimal assembly before use. To assemble the machine: 1.. Connect the bender handle to the machine with the M10-1.5 x 40 hex bolts and 10mm flat washers (Figure 5). Figure 5.. Attaching handle. x2 Handle Hex Bolt Flat Washer Figure 7.. Work stop. Work Stop Work Stop Rod Knob 2.. insert the stop rod with the M12-1.75 hex nut into the base. Tighten the hex nut against the base to secure it (Figure 6). Work Stop Rod Hex Nut Figure 6.. Attaching work stop rod. -3 T10050 Right angle iron Bender Mounting Operations once you have confirmed that your machine is assembled and functioning properly, mount it to a workbench through the holes in the base. Be sure the workbench will remain stable when bending force is applied to the machine. if necessary, anchor the workbench to a wall or the floor to provide the necessary stability. The strongest mounting option is a "Through Mount" where holes are drilled all the way through the workbench, and hex bolts, washers, and hex nuts are used to secure the machine to the workbench. .................................................................................................................................. Figure 8.. example of a through mount setup. another option for mounting is a "direct Mount" where the machine is simply secured to the workbench with a lag screw. .................................................................................. Figure 9.. example of a direct mount setup. Creating Bends 1.. lift the clamp cam shaft to release the clamp die. Rotate the clamp die as necessary to accommodate the thickness of your work- piece, then slide the clamp cam shaft back into the base (Figures 10 & 11). Cam Shaft die Figure 10.. Lifting clamp cam shaft and die. Figure 11.. Clamp die positions. -4 T10050 Right angle iron Bender 2.. place the workpiece into the clamp and adjust the workpiece position as needed. Rotate the clamp cam shaft to clamp the workpiece (Figure 12). Figure 12.. Clamping workpiece. —if the clamp die does not move far enough to fully clamp the workpiece, repeat Steps 1 & 2. 3.. adjust the bending plate to support the work- piece while bending (Figure 13). .... Figure 13.. Tightening bending plate. NOTICE Use the machine only as it is intended to be used.. Adding cheater bars or other methods of increasing leverage may damage the machine and will void the warranty.. 4.. use the handle to bend the workpiece to the desired angle (Figure 14). Figure 14.. Bending workpiece. 5.. loosen the bending plate and clamp cam shaft to release the workpiece (Figure 15). ...... Figure 15.. Releasing workpiece. -5 T10050 Right angle iron Bender 2.. Bend the workpiece to the desired angle, Repetitive Bends then slide the angle stop against the bender base. Turn the angle stop to lock it in posit...
Эта инструкция также подходит к моделям:Блендеры - T10050 (1.69 mb)
Блендеры - T10050 (1.69 mb)
Блендеры - T10050 (1.69 mb)