Войти:
Оценок - 3, средний балл: 3.7 ( )

Инструкция по эксплуатации Zenoah, модель G300TS

Производитель: Zenoah
Размер: 289.43 kb
Название файла: 014cd4d9-1308-f6f4-5d24-cc5a71bc8ea2.pdf
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


(MA11) For a replacement plug, use Champion RCJ- 6Y(noise-proof) or CJ-6Y, or NGK BPMR7A. DRIVE SPROCKET Periodically check the drive sprocket for wear and damage, and replace when the teeth have worn over 0.04 inch, or when any damage has been observed. (MA12) HANDLE MOUNTING JOINTS Inspect the handle mounting joints and replace when any adhered part is peeled off or a crack is observed on the rubber part. Also replace when the inside of the rear damper metal has worn remarkably. .19. 9. Maintenance MA13 10. Storage SPARK ARRESTER RedMax engines are equipped with a spark arresting screen at the exhaust port. Periodically check and keep it in good condition. In the State of California it is required by law (Section 4442 of the California Public Resources Code) to have a spark arrester when a gas powered tool is used in any forest covered, brush covered, or grass covered unimproved land. (MA13) 1. Empty the fuel tank and run the engine out of fuel. 2. Empty the oil tank. 3. Clean the entire unit. 4. Store the unit in a dry place out of the reach of children. .20 . 11.Parts list CHAINSAWS G310TS NOTE : 1. Use KOMATSU ZENOAH genuine parts as specified in the parts list for repair and/or replacement. 2. KOMATSU ZENOAH does not warrant the machines, which have been damaged by the use of any parts other than those specified by the company. 3. When placing parts orders for repair and/or replacement, check if the model name and the serial number are applicable to those specified in the parts list, then use parts number described in the parts list. 4. The contents described in the parts list may change due to improvement. 5. The parts for the machine shall be supplied seven (7) years after the machine is discontinued. [It is possible that some specific parts may be subject to change of their delivery term and list price within the limit of ten (7) years after the machine is discontinued. It is also possible that some parts may be available even after the limit of seven (7) years.] APPLICABLE SERIAL NUMBERS : 002191 and up May. 2000 .21. 11.Parts list G310TS .22. Fig.1 POWER UNIT G310TS (S/N 002191 and up) .23. Q'TY Key# PART NUMBER DESCRIPTION NOTE /UNIT 2870-12111 CYLINDER 1 2633-15100 MUFFLER ASS’Y 1 2633-15110 • BASE 1 2633-15120 • COVER 1 2630-15130 • BUFFLE 1 2633-15150 • SPARK ARRESTER 1 2633-15160 COVER 1 2630-15210 GASKET 1 3330-15220 BOLT 2 2870-21111 CRANKCASE 1 01252-30530 BOLT 4 2870-22102 VALVE ASS’Y 1 2870-22211 GASKET 1 3330-141211 GASKET 1 2875-31103 ENGINE CASE COMP. 1 2870-31510 VALVE 1 2831-31202 FUEL PIPE ASS’Y 1 1492-85410 • PIPE 1 1850-85300 • FILTER ASS’Y 1 1260-85460 • CLIP 2 3350-34320 • ELBOW 1 2631-31250 • GROMMET 1 3317-86100 • BREATHER ASS’Y 1 2630-31301 OIL PIPE ASS’Y 1 1492-85410 • PIPE 1 2630-31321 • GROMMET 1 2630-31330 • JOINT 1 2630-31350 • FILTER 1 1492-85410 PIPE 1 3370-31210 PIN 1 2630-31510 VALVE ASS'Y 1 2870-22251 SEAL 1 2630-31650 CAP 1 2870-31750 SCREW 4 2841-31800 CAP ASS'Y 2 2630-31820 • GASKET 2 ––––––––– STOPPER 2630-31913 COVER 2 2630-31950 SCREW 2 2632-32103 FRONT HANDLE ASS'Y 1 2630-32121 • JOINT (A) 1 2630-32151 • STOPPER 1 2630-32170 • SCREW 1 2630-32170 SCREW 1 2630-32610 SCREW 1 2630-33103 REAR HANDLE COMP. 1 3330-33250 • STOPPER 2 3310-33262 • SPRING 1 3310-33271 • KNOB 1 2630-33312 THROTTLE LEVER 1 3356-33321 SPRING 1 04025-00524 PIN 1 3356-33352 ARM 1 Q'TY Key# PART NUMBER DESCRIPTION NOTE /UNIT 54 2630-33410 COVER 1 55 2630-31950 SCREW 1 56 2630-33511 JOINT (B) 3 57 2640-33530 BOLT 3 58 2630-33610 SCREW 6 59 2870-41111 PISTON 1 60 3319-41210 RING 1 61 3304-41310 PIN 1 62 3310-41320 SNAP RING 2 63 3310-41410 BEARING 1 64 1650-41510 WASHER 2 65 2870-42002 CRANKSHAFT COMP. 1 66 06030-06201 BEARING 2 67 2630-43150 OIL SEAL 1 68 04065-03212 SNAP RING 1 69 2169-21210 OIL SEAL 1 70 1650-43230 NUT 1 71 2872-51111 CLUTCH DRUM 1 72 3310-51310 BEARING 1 73 2870-51200 CLUTCH ASS'Y 1 74 ––––––––– • SHOE 75 3317-51240 • BOSS (B) 1 76 2870-51230 • SPRING 1 77 2630-98610 • BOSS (A) 1 78 2872-54004 CHAIN BRAKE ASS'Y 1 79 2872-53115 • COVER 1 80 2872-54112 • GUARD 1 81 2872-54120 • SPRING 1 82 0263-80530 • SCREW 1 83 2872-54140 • SPACER 1 84 2850-54211 • SPACER 1 85 2872-54220 • WEIGHT 1 86 2872-54230 • SPRING 1 87 2851-54270 • SPRING 1 88 01641-20508 • WASHER 1 89 3310-53331 • NUT (B) 1 90 2851-54301 • LEVER COMP. 1 91 2851-54350 • PIN 1 92 2670-54410 • ARM 1 93 2872-54510 • BAND 1 94 3356-24140 • PIN 1 95 2670-54610 • SPRING 1 96 2872-54623 • COVER 1 97 2630-33610 • SCREW 3 98 2831-54120 LABEL 1 99 2648-54350 LABEL 1 100 3350-53410 NUT 1 101 2870-53310 PLATE 1 102 2630-53330 SCREW 1 103 3310-53320 NUT (A) 1 104 2630-53412 CATCHER 1 105 2630-32170 SCREW 1 106 2630-55103 OIL PUMP ASS'Y 1 Key# PART NUMBER DESCRIPTION Q'TY /UNIT NOTE 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151 152 153 154 155 156 2630-55160 0261-00416 2630-55211 2630-55251 2630-5...

Эта инструкция также подходит к моделям:
Бензо и электропилы - G310TS (289.43 kb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории