Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
Keep the spike or the saw body against the wood when cutting. Use only genuine accessories and spare parts. We recommend you have your unit periodically checked and serviced by an authorised dealer. Do not use chainsaw above shoulder height. 5 Do not operate the chainsaw near a naked flame or spilled fuel. Only operate the chainsaw outside and in well ventilated areas. After re-fuelling, always wipe off any spilled fuel. Move the chainsaw away from the fuelling point before starting the engine. ENGLISH - 2 6 Keep by-standers and animals out of the work area; at a minimum distance of 10 m or twice the timber length. If necessary, use warning signs to keep on-lookers at a distance. Carefully survey the working site to note any hazards, eg. roads, paths, electricity cables, dangerous trees etc. Do not use the chainsaw if the device for stopping the chain (safety chainbrake) does not work correctly. Never place hands on the chain whilst the engine is running. Ensure someone is within hearing distance in case of an accident. If this is not possible, it is recommended that users operating chainsaws in remote areas carry an adequate first-aid kit with them and ensure someone knows their location. Never leave the engine running while the tool is unattended. NEVER USE A CHAIN SAW THAT HAS FAULTY SAFETY EQUIPMENT! Carry out the inspection, maintenance and service routines listed in this section. ONLY USE ORIGINAL SPARE PARTS AND ACCESSORIES. C. Bar and chain installation - Intenz Ensure engine is always switched off before fitting or adjusting chain. Wear a pair of protective gloves when fitting or adjusting chain. 1 Ensure chain brake lever is in disengaged position (A). Remove retaining nuts (B) and cover. 2 Turn the adjusting screw (D) counterclockwise taking it fully back. 3 Feed chain into bar groove ensuring correct direction of chain (P). 4 Work the chain around sprocket and set the bar as illustrated, make the lower hole (F) coincide with the pin (G) of the adjusting screw. 5 Reposition side cover. Fit spike as illustrated. 6 Lock nuts (B) finger tight. Adjust chain tension pin by turning screw (D) so that when lifting the chain an entire drive link is just visible. The chain is correctly tensioned when there is no slack on the underside of the bar, and it runs freely in bar groove. Tighten the bar retaining nuts with the wrench, pushing bar tip upwards. INTENZ Turn the adjusting screw (I) counterclockwise taking it fully back. Feed chain into bar groove ensuring correct direction of chain (P). Lock nuts (B) finger tight. Adjust chain tension pin by turning screw (I) so that when lifting the chain an entire drive link is just visible. The chain is correctly tensioned when there is no slack on the underside of the bar, and it runs freely in bar groove. Tighten the bar retaining nuts with the wrench, pushing bar tip upwards. D. Fuel mix Do not use any other type of fuel than the type recommended in this manual. This product is equipped with a two-str...
Эта инструкция также подходит к моделям:Бензо и электропилы - P 540E 40 CC (1.96 mb)
Бензо и электропилы - 95390011700 (1.96 mb)
Бензо и электропилы - Euromac S42 (1.96 mb)
Бензо и электропилы - Euromac S43 42 CC (1.96 mb)