Оценок - 4, средний балл: 4.5 ( )

Производитель: Makita Размер: 6.26 mb Название файла: Язык инструкции:

Additional safety precautions The following additional safety precautions should be observed by all users of chain saws: 1. Do not operate a chain saw when you are fatigued. 2. Use safety footwear; snug-fitting clothing; protective gloves; and eye, hearing, and head protection devices. 3. Use caution when handling fuel. Move the chain saw at least 10 feet (3 m) from the fueling point before starting the engine. 4. Do not allow other persons to be near the chain saw when starting or cutting with the chain saw. Keep bystanders and animals out of the work area. 5. Do not start cutting until you have a clear work area, secure footing, and a planned retreat path from the falling tree. 6. Keep all parts of your body away from the saw chain when the engine is running. 7. Before you start the engine, make sure that the saw chain is not contacting anything. 8. Carry the chain saw with the engine stopped, the guide bar and saw chain to the rear, and the muffler away from your body. 9. Do not operate a chain saw that is damaged, is improperly adjusted, or is not completely and securely assembled. Be sure that the saw chain stops moving when the throttle control trigger is released. 10. Shut off the engine before setting it down. 11. Use extreme caution when cutting small size brush and saplings because slender material may catch the saw chain and be whipped towardyou or pull you off balance. 12. When cutting a limb that is under tension be alert for springback so that you will not be struck when the tension on the wood fibers is released. 13. Keep the handles dry, clean, and free of oil or fuel mixture. 14. Operate the chain saw only in well-ventilated areas. 15. Do not operate a chain saw in a tree unless you have been specifically trained to do so. 16. All chain saw service, other than the items listed in the owner’s manual maintenance instructions, should be performed by MAKITA . (For example, if improper tools are used to remove the flywheel or if an improper tool is used to hold the flywheel in order to remove the clutch structural damage to the flywheel could occur and could subsequently cause the flywheel to burst.) 17. When transporting your chain saw, use the chain protection cover. 18. Low kickback bars and low kickback chains are designed to reduce the risk of kickback injury. Ask your MAKITA dealer about these devices. General Safety Precautions General Safety Precautions WARNING ! Reactive forces, including kickback, can be dangerous. Careless or improper use of any chain saw may cause serious or fatal injury. Have your DOLMAR dealer show you how to operate your chain saw. Observe all applicable local safety regulations, standards and ordinances. 1 WARNING! Minors should never be allowed to use a chain saw. Bystanders, especially children and animals should not be allowed in the area where a chain saw is in use (fig. 1). Never let the saw run unattended. Store it in a locked place away from children. Fill the fuel tank to 7/8 th full (see storing the saw). Do not lend your chain saw without this owner’s manual. Be sure that anyone using your saw understands the information given. Proper use of a chain saw involves 1. the operator 2. the saw 3. the use of the saw. Discription of symbols used on chain saws: Z 62.1-95 and Compliance with Z 62.3-96 CSA -Standards Class 1A Compliance withANSI B175.1-1991 ANSI -Standards ® Chain Saw listed in accordance with American National Standard Safety 45M6 Specifications for Gasoline Powered Chain Saws (ANSI B 175.1-1991). max. CKA 45O max. CKA 40O Maximum Computed Kickback Angle (CKA)* without using the chain brake when using the recommended bar and chain combinations (In this example the CKA is 45°). MaximumComputed Kickback Angle (CKA)* with using the chain brake when using the recommended bar and chain combinations (In this example the CKA is 40°). Contact of the guide bar tip with any object should be avoided! Tip contact may cause the guide bar to move suddenly upward and backward, which may cause serious injury! XXX.YYY.ZZZ XXX.YYY.ZZZ Always use two hands when operating the chain saw! Reduced Kickback Bar and Chain combination that has been evaluated with the power head to achieve kickback protection (according to ANSI and CSA standards). * The Computed Kickback Angle is a calculated value from energies measured on a test bench.It is not the angle of the guide bar moved upward in case of a KICKBACK. The operator Physical Condition You must be in good physical condition and mental health and not under the influence of any substance (drugs, alcohol), which might impair vision, dexterity or judgment. 2 WARNING ! Prolonged use of chain saws exposing the operator to vibrations may produce Whitefinger disease (Raynaud’s phenomenon). This phenomenon reduces the hand’s ability to feel and regulate temperature, produces numbness and burning sensations and may cause nerve and circulation damage and tissue necrosis. All MAKITA saws are therefore provided with an antivibrati...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: