Оценок - 4, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
BEFORE YOU BEGIN • Observe all local plumbing and building codes. • Carefully inspect the new Ring / Legs for damage. • Determine which tools and materials are necessary by reading the complete mounting instructions and examining the job you have to do. INSPECT FOR DAMAGE • Immediately upon receipt, inspect the Ring / Legs contents before installing. Should inspection reveal any damage or defect in the finish, do not install on the bath. Damage or defect to the finish claimed after the Ring / Legs are installed is excluded from the warranty. • Jacuzzi Luxury Bath’s responsibilty for shipping damages ceases upon delivery of the products in good order to the carrier. Refer any claims for damage to the carrier. • For definitions of warranty coverage and limitations, refer to the published warranty information packed with the product. • Jacuzzi Luxury Bath is not responsible for any defects that could have been discovered, repaired, or avoided by following this inspection and testing procedure. TOOLS AND MATERIALS: The following tools and materials are required but not supplied. Safety glasses, tape measure, clear silicon, caulking gun, philips screw driver, and flat head screw driver. .............................................................................................................................. .............................................................................................................................................................................................. GN77 GALLERY 6/ RIVA 6 RING GN75 GALLERY 6/ RIVA 6 LEGS © Jacuzzi Luxury Bath • 14525 Monte Vista Ave • Chino • California • 91710 • #GV64000 02/09 © Jacuzzi Luxury Bath • 14525 Monte Vista Ave • Chino • California • 91710 #GV64000 02/09 • 1. • Place Ring upside down to identify the dimples as shown in Fig. 1. • Locate the Ring and Hanger brackets and place them as shown in Fig. 2. • Using a Philips Screw driver, attatch the ring and hanger bracket to the Ring using the provided philips screws. 2. • Once all the Ring and hanger brackets have been installed, carefully flip the ring over and install onto the freestanding skirt as shown in Fig. 4. Continue onto installing your Freestanding Bath Tub. Ring Installation: ................ .................. ........................ ............................ .................... .............. .................... .............. ............ .............. Ring Bracket / Ring Hanger Bracket Fig. 2 Ring Installtion Detail Fig. 3 .......................... ........................................ .......................... ........................................ .......................... ........................................ .......................... ..............................
Эта инструкция также подходит к моделям:Бассейны - GA95 (303.64 kb)
Бассейны - GA99 (303.64 kb)
Бассейны - GL25 (303.64 kb)