Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
• As sun shines on the collector, Collector Cross Section the water is then heated as it moves through it. • Water is heated as it moves through the many tubes in the solar collectors. • The heated water is returned back to the pool, through • Tube and web design traps heat and catches your return lines. light as the sun moves across the sky. • Tough polypropylene material won’t rust, corrode heated pool with no • You enjoy your own or scale. Plus, the collector is reversible. fuel costs. PLEASE READ THIS MANUAL CAREFULLY. YOUR ENJOYMENT OF YOUR SOLAR HEATED POOL AND YOUR WARRANTY ARE AFFECTED BY HOW YOUR SOLAR HEATING SYSTEM IS INSTALLED CAUTION: a) Solar collectors are often installed on the roofs of buildings. Unless you are very familiar with working on roofs and have the proper ladders and safety equipment for such work, you should hire someone with the necessary experience to do the installation. Failure to observe safe practices on a roof or other elevated structure may result in falling, leading to serious injury to you. b) When installing collectors on the ground, do not build a rack support that could allow children access into the pool. IMPORTANT READ THIS ENTIRE MANUAL BEFORE STARTING ORIENTATION How Well Does Solar Heating Work? A properly sized and installed system will raise pool temperatures up to 100F during the season. You will only want to circulate water through the solar collector when the sun is shining. When it's cloudy or rainy, solar won't work as well (and you probably won't be swimming during those times), but your water will be back up to temperature after one or two warm days. Do I Need A Special Pump? If your pool pump is in good working condition, there shouldn't be any problem using your existing pump. A one HP pump will handle installations up to 30 feet away from the pool equipment and one story up. If the collectors are cool to touch when the water is running through them on a warm sunny day, you are getting enough flow. Where Can I Put The Solar Collectors? Anywhere you get at least 6 hours of full sun during the day. The longer the collectors are in full sun, the better they will work. If you are mounting the solar on an angle (like a roof or rack), the collectors should face in a southerly direction. For roof or rack mounting, you’ll need 1 SK-43 mounting kit (one SK43 will secure up to two S220 collectors). For high wind areas, we recommend one SK-34 High Wind Kit for each collector. Call SmartPool at 1-888-560-7665 for ordering info. What Tools Will I Need? • Flat head screwdriver or 5/16" nut driver For roof or rack mounting you will also need: • Power drill • 1/8" drill bit and a Phillips head bit • Silicone sealant (GEII or equivalent) What additional parts will I need to install the solar system on a roof? • 1 SmartPool Mounting Kit SK-43 (will secure up to two S220 collectors). High wind SK-34 for each collector in high wind areas. • You will need the correct amount of 1 1/2" Schedule 40 PVC pipe for the plumbing, going to and from your pool equipment. • You will also need PVC primer, glue, and fittings (available where you buy PVC pipe). What additional parts will I need to install the solar system on the ground or on a rack? • For a ground mount installation you will require 2 hoses - one that will reach from the pool equipment to the collector and one that reaches from the collector back to the pool. • For a rack mount installation you'll need SmartPool’s mounting kit SK-43. For high wind areas you will need one SK-34 for each collector. USE OF NON-FACTORY MOUNTING HARDWARE WILL VOID YOUR WARRANTY! WARNING! POSITION THE RACK SO THAT IT DOES NOT PROVIDE ACCESS TO THE POOL FOR CHILDREN. How much will the solar system weigh when filled with water? Each solar box will weigh approximately 40 lbs. when filled with water. There is very little additional load on your roof since the weight is dispersed over a large area. Pool Sizes Number of Solar Boxes Area NeededRound Oval 12’ - 18’ 12’ x 24’ 1 3 ft x 21 ft 21’ - 24’ 15’ x 30’ - 16’ x 25’ 2 5 ft x 21 ft 27’ - 28’ 16’ x 32’ - 18’ x 34’ 3 7 ft x 21 ft Use a solar blanket to hold in heat at night or during cool weather. 2 Product # S220 Kit Components Kit Qty Item # Description 1 1 SCPNL220 SC018HSE 2’ x 20’ Polypropylene Solar Collectors 18’ Plastic Flex Hose SK-32 System Kit for S220 2 69003 Elbow Connectors 2 69002 PVC End Caps 1 1/2” FPT 2 SC125CLMP 1 1/4” Stainless Steel Hose Clamps 35-51 1 60554 Teflon Tape 1/2” 1 Installation Manual w/Warranty Statement SC018HSE SK-32 SunHeater collectors are manufactured with special molds and materials designed to provide you with the most durable, high performance solar pool heating system available. Note: during manufacturing certain mechanical incisions are required to complete the assembly of the collector (see photos on right). These are normal and do not adversely affect the performance or durability of your SunHeater. Please Note: Small holes in collector (see photo at r...