Оценок - 4, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
This output will drive any OMEGA® flow ratemeter, counter, controller or pulse input data acquisition board. Unpacking Remove the Packing List and verify that you have received all equipment. If you have any questions about the shipment, please call the Customer Service Department. When you receive the shipment, inspect the container and equipment for any signs of damage. Note any evidence of rough handling in transit. Immediately report any damage to the shipping agent. NOTE The carrier will not honor any claims unless all shipping material is saved for their examination. After examining and removing contents, save packing material in the event reshipment is necessary. The following items are supplied in the box: • FLSC-AMP-A Signal Conditioner • Operator’s Manual Hookup (Refer to Figure 1) For electrical connections, the terminal strip will accommodate up to a 14 gauge wire. 18-20 gauge is recommended. Note: The signal lines from the magnetic pick-up should be shielded and kept less than ten feet and away from relays, solenoids, or other sources of electrical noise. The signal shield should be connected to power/common. The module output is recommended to make long distance runs. 1 2 3 4 5 OUTPUT + POWER SUPPLY – SIGNAL INPUT POWER / COMMON (ALSO USED FOR OUTPUT RETURN) + SIGNAL MOUNTING HOLES (2) USE 8-32 SCREWS Figure 1. Terminal $ Mounting The FLSC-AMP-A module may be mounted using the screw holes provided in the molded housing. Double- sided tape, Velcro, or glue may also be used to secure the module in place. The FLSC-AMP-A module can also be snap track mounted using an adapter plate. FLSC-AMP-A Signal Conditioner Specifications Power: 8 to 24 Vdc Input Frequency: 20 Hz to 20 KHz Input Voltage: Sinusoidal 50mV p-p to 50V p-p Input Impedance: 10 K ohms Output: 100 mA sink max. with 4.7K internal pull-up resistor Temperature Range: -10 to 60°C Weight: 1 oz. Dimensions 1 2 3 4 5 .650 (16.50) .650 (16.50) 1.750 (44.45) DIA. 1.150 (29.21) 1 2 3 4 5 .750 (19.05) .185 DIA. THRU .250 DIA. THRU WARRANTY/DISCLAIMER OMEGA warrants this unit to be free of defects in materials and workmanship and to give satisfactory service for a period of 13 months from date of purchase. OMEGA Warranty adds an additional one (1) month grace period to the normal one (1) year product warranty to cover handling and shipping time. This ensures that OMEGA’s customers receive maximum coverage on each product. If the unit should malfunction, it must be returned to the factory for evaluation. OMEGA’s Customer Service Department will issue an Authorized Return (AR) number immediately upon phone or written request. Upon examination by OMEGA, if the unit is found to be defective it will be repaired or replaced at no charge. However, this WARRANTY is VOID, if the unit shows evidence of having been tampered with or shows evidence of being damaged as a result of excessive corrosion; or current, heat, moisture or vibration; improper specification; misapplication; misuse or other operating conditions outside of OMEGA’s control. Components which wear or which are damaged by misuse are not warranted. These include contact points, fuses, and triacs. OMEGA is pleased to offer suggestions on the use of its various products. Nevertheless, OMEGA only warrants that the parts manufactured by it will be as specified and free of defects. OMEGA MAKES NO OTHER WARRANTIES OR REPRESENTATIONS OF ANY KIND WHATSOEVER, EXPRESSED OR IMPLIED, EXCEPT THAT OF TITLE AND ALL IMPLIED WARRANTIES INCLUDING ANY WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE HEREBY DISCLAIMED. LIMITATION OF LIABILITY: The remedies of purchaser set forth herein are exclusive and the total liability of OMEGA with respect to this order, whether based on contract, warranty, ne...
Эта инструкция также подходит к моделям:Автоусилители - M1945 (384.89 kb)