Войти:
Оценок - 2, средний балл: 3.5 ( )

Инструкция по эксплуатации Carson, модель SA-441-83F X

Производитель: Carson
Размер: 80.56 kb
Название файла:
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


The siren tone is controlled manually with SIREN button. Both speakers produce manual tone slightly out of phase to give stereo effect. PA Override available in this mode. WAIL -The siren produces dual Wail. Each speaker produces independent Wail tone. Dual Yelp and PA Override available in this mode. YELP -The siren produces dual Yelp. Each speaker produces independent Yelp tone. Phaser and PA Override available in this mode. WAIL/YELP -The siren produces Wail to one speaker and Yelp to the other speaker. Phaser and PA Override available in this mode. OVERRIDE FUNCTIONS (Dual Mode) PUBLIC ADDRESS (PA) OVERRIDE -Same as normal mode. HORN OVERRIDE -Same as normal mode, both speakers produce same Horn tone. DUAL YELP OVERRIDE -Available only in Dual Wail mode. By momentarily pressing the SIREN button the tone output is switched to the Dual Yelp tone. Pressing the button again switches the tone output back to Dual Wail. PHASER OVERRIDE -By pressing the SIREN button the siren tone output is replaced by the Phaser tone. Both speakers produce same Phaser tone. The siren tone resumes when the button is released. TB0335B Page 7 of 10 10/18/03 SERVICE This unit is designed to provide years of reliable service under even the worst conditions. Many times there may appear to be a problem with the unit when the true problem is in the speaker(s) or improper installation. The following chart shows typical symptoms and possible causes. A blown panel fuse(s) doesn't necessarily mean that the unit is bad. If a speaker or speaker lead is shorted this fuse will blow before the unit is damaged. Disconnect the SPKR leads and replace the fuse. If the siren emits a sound when in the Yelp position it is OK. Check the speaker(s) or leads for possible shorting. Note: Older versions of this amplifier unit used one 20AMP fuse to supply both internal amplifiers. This means that if one internal amplifier output is shorted and blows the fuse, the other internal amplifier will also lose power even though it may be fine. Be sure to check both amplifier unit outputs for shorted wiring or speaker. PROBLEMS Symptom Possible Cause Check No Power or siren output Power switch not turned on Bad Speaker Connector or connections loose Panel fuse(s) blown Loose connection at power source Does backlighting come on? Do you hear a “pop” when turned on? With siren on, yelp selected, listen for tone in amplifier. Is an external fuse or circuit breaker used? Are the power leads connected to a good buss? No siren tone – PA works High Voltage Protection Mic Button stuck The input voltage must be less than highest rating. Does Mic Button release properly? No PA PA volume not set properly Try turning the PA volume control. Distorted siren sound Speaker assembly loose Intermittent Aux Input connection Low Vehicle voltage Is the speaker bell or tip loose? Is the Aux Input used and wired properly? The input voltage must be greater than lowest rating. Intermittent siren tone High Voltage Protection Connector loose Loose connection at power source Mic Button activation Circuit breaker in supply connection Is the vehicle voltage regulator working properly? Is the connector tight on the back of the unit? Check for loose leads back to power source. Is something lying on the microphone? Is a circuit breaker used with at least 50A rating? Horn or manual stuck on Siren switch stuck Aux Input improperly connected Does the Siren pushbutton switch return fully when released? Is the Aux Input used and wired properly? No Radio Unit not connected to a radio Radio volume too low Is the radio connected properly to the unit? Can you hear the radio in the vehicle? Try adjusting the internal radio volume control. Wrong siren tone Ground system noise Are control head and amplifier connected to good ground? Dual mode switch does not work Only one internal amplifier works One speaker damaged Is one fuse on the amplifier blown? Try replacing the speaker. RETURN If you have any questions concerning this or any other Carson product, please contact our Technical Service Department at (888) 577-6877. Many issues can be handled over the phone. We can also be reached via e-mail at service@carsonsirens.com If a product must be returned for any reason, please contact our Technical Service Department to obtain a Returned Merchandise Authorization number (RMA#) before you ship the product to Carson. Please write the RMA# clearly on the package near the mailing label. Be sure to provide a return address, contact and phone number, along with a brief description of the problem. TB0335B Page 8 of 10 10/18/03 PARTS 3 9 6 10 SA 441SA 441 1 7 2 4 8 RADIORADIO HRN/TTHRN/TT MANMAN WAILWAIL YELPYELP PHASR/WPHASR/W--YY SIRENSIREN PA VOL POWERPOWER OFF/ON ON 5 13 (one pair each end) (output for speaker B shown) 12 11 Control Head Item Part # Description 1 8025 DRS/CAP Button, red w/ dress nut (C&K #801803000 Cap, #702501201 Nut) (for pushbutton switch) CP3040 Cable, control head power ES00003-09 Cable, micr...

Эта инструкция также подходит к моделям:
Автоусилители - SA-441-83F (80.56 kb)
Автоусилители - SA-441-83FX (80.56 kb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории