Оценок - 3, средний балл: 4.7
(
)
)
|
Фрагмент инструкции
Press again to reverse the door during the closing cycle or to stop the door while it's opening. To prevent possible SERIOUS INJURY or DEATH from a falling garage door: • If possible, use emergency release handle to disengage trolley ONLY when garage door is CLOSED. Weak or broken springs or unbalanced door could result in an open door falling rapidly and/or unexpectedly. • NEVER use emergency release handle unless garage doorway is clear of persons and obstructions. • NEVER use handle to pull door open or closed. If rope knot becomes untied, you could fall. The door should be fully closed if possible. Pull down on the emergency release handle and lift the door manually. To reconnect the door to the opener, press the door control push button. The lockout feature prevents the trolley from reconnecting automatically, Pull the emergency release handle down and back (toward the opener). The door can then be raised and lowered manually as often as necessary. To disengage the lockout feature, pull the handle straight down. The trolley will reconnect on the next UP or DOWN operation. Trolley Release Arm NOTICE Emergency Release Handle (Pull Down) Trolley Release Arm NOTICE Emergency Release Handle (Down and Back) LOCKOUT POSITION MANUAL DISCONNECT POSITION 32 Care of Your Opener LIMIT AND FORCE ADJUSTMENTS: Weather conditions may cause some minor changes in door operation requiring some readjustments, particularly during the first year of LIMIT CONTROLS operation. (Left side panel) Pages 28 and 29 refer to the limit and force adjustments. Only a screwdriver is required. Follow the instructions carefully. Repeat the safety reverse test Open Force KG KG139 75 5 139 7Close Force (page 30) after any adjustment of FORCE CONTROLS limits or force. (Back panel) MAINTENANCE SCHEDULE Once a Month • Manually operate door. If it is unbalanced or binding, call a trained door systems technician. • Check to be sure door opens & closes fully. Adjust limits and/or force if necessary. (See pages 28 and 29.) • Repeat the safety reverse test. Make any necessary adjustments. (See page 30.) Twice a Year • Check chain tension. Disconnect trolley first. Adjust if necessary (see page 11). Once a Year • Oil door rollers, bearings and hinges. The opener does not require additional lubrication. Do not grease the door tracks. The Remote Control Battery To prevent possible SERIOUS INJURY or DEATH: • NEVER allow small children near batteries. • If battery is swallowed, immediately notify doctor. To reduce risk of fire, explosion or chemical burn: • Replace ONLY with 3V2032 coin batteries. • Do NOT recharge, disassemble, heat above 100°C (212°F) or incinerate. The lithium battery should produce power for up to 5 years. To replace battery, use the visor clip or screwdriver blade to pry open the case as shown. Insert battery positive side up (+). Dispose of old battery properly. Replace ONLY with 3V2032 coin batteries. Battery positive side up (+) Having a Problem? 1. The opener doesn't operate from either the Door Control or the remote control: • Does the opener have electric power? Plug a lamp into the outlet. If it doesn't light, check the fuse box or the circuit breaker. (Some outlets are controlled by a wall switch.) • Have you disabled all door locks? Review installation instruction warnings on page 11. • Is there a build-up of ice or snow under the door? The door may be frozen to the ground. Remove any restriction. • The garage door spring may be broken. Have it replaced. • Repeated operation may have tripped the overload protector in the motor. Wait 15 minutes and try again. 2. Opener operates from the remote, but not from the Door Control: • Is the door control lit? If not, remove the bell wire from the motor unit terminals. Short the red and white terminals by touching both terminals at the same time with a piece of wire. If the opener runs, check for a faulty wire connection at the door control, a short under the staples, or a broken wire. • Are the wiring connections correct? Review Installation Step 6, page 18. 3. The door operates from the Door Control, but not from the remote control: • Is the door push bar flashing? If your model has the Lock feature, make sure it is off. • Program the opener to match the remote control code. (Refer to instructions on the motor unit panel.) Repeat with all remotes. 4. The remote control has short range: • Change the location of the remote control in your car. • Check to be sure the antenna on the side or back panel of motor unit extends fully downward. • Some installations may have shorter range due to a metal door, foil backed insulation, or metal garage siding. 5. Opener noise is disturbing in living quarters of home: • If operational noise is a problem because of proximity of the opener to the living quarters, the Vibration Isolator Kit 89LM can be installed. This kit was designed to minimize vibration to the house and is easy to install. NOTICE: To comply with FCC and or Industry Canada (IC) ru...