Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
The Auto Off function does not operate.
Program service name flashes.
The unit is turned on. The Auto Off function activates
There is no alternative frequency for the current
after turning off the unit.
station.
t Turn off the unit.
t Press +>/–. while the program service
DSO does not function.
name is flashing. “PI SEEK” appears and the unit
• Depending on the type of car interior or type of
starts searching for another frequency with the
music, DSO may not have a desirable effect.
same PI (Program Identification) data.
Radio reception
USB playback
The stations cannot be received.
You cannot play back items via a USB hub.
The sound is hampered by noises.
This unit cannot recognize USB devices via a USB
• The connection is not correct.
hub.
t Connect a power antenna (aerial) control lead
Cannot play back items.
(blue) or accessory power supply lead (red) to the
A USB device does not work.
power supply lead of a car’s antenna (aerial)
t Reconnect it.
booster (only when your car has built-in FM/
The USB device takes longer to play back.
MW/LW antenna (aerial) in the rear/side glass).
The USB device contains files with a complicated tree
t Check the connection of the car antenna (aerial).
structure.
t If the auto antenna (aerial) will not go up, check
The display items do not scroll.
the connection of the power antenna (aerial)
• A large number of characters may not scroll.
control lead.
t
• “A.SCRL” is set to “OFF.”
When the DSO mode is on, the sound is
sometimes hampered by noises.
t Set “A.SCRL-ON” (page 19).
Set the DSO mode to “OFF” (page 18).
t Press and hold (DSPL) (SCRL).
A beep sounds.
Preset tuning is not possible.
During playback, the USB device has been
• Store the correct frequency in the memory.
disconnected.
• The broadcast signal is too weak.
t Before disconnecting a USB device, make sure to
Automatic tuning is not possible.
stop playback first for data protection.
• Setting of the local seek mode is not correct.
t
The sound is intermittent.
Tuning stops too frequently:
The sound may be intermittent at a high-bit-rate of
Set “LOCAL-ON” (page 19).
t
more than 320 kbps.
Tuning does not stop at a station:
Set “LOCAL-OFF” (page 19).
• The broadcast signal is too weak.
t Perform manual tuning.
During FM reception, the “ST” indication
flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
t Set “MONO-ON” (page 19).
An FM program broadcast in stereo is heard in
monaural.
The unit is in monaural reception mode.
t Set “MONO-OFF” (page 19).
RDS
The SEEK starts after a few seconds of
listening.
The station is non-TP or has weak signal.
t Deactivate TA (page 12).
No traffic announcements.
• Activate TA (page 12).
• The station does not broadcast any traffic
announcements despite being TP.
t Tune in another station.
PTY displays “- - - - - - - -.”
• The current station is not an RDS station.
• RDS data has not been received.
• The station does not specify the program type.
24
...