|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
In such a case, consult your nearest Sony dealer. Fuse (10 A) Warning Never use a fuse with an amperage rating exceeding the one supplied with the unit as this could damage the unit. Cleaning the connectors The unit may not function properly if the connectors between the unit and the front panel are not clean. In order to prevent this, detach the front panel (page 7) and clean the connectors with a cotton swab dipped in alcohol. Do not apply too much force. Otherwise, the connectors may be damaged. Main unit Back of the front panel Notes • For safety, turn off the ignition before cleaning the connectors, and remove the key from the ignition switch. • Never touch the connectors directly with your fingers or with any metal device. Removing the unit 1 Remove the front cover 1 Detach the front panel (page 7). 2 Press the clip inside the front cover with a thin screwdriver. 3 Repeat step 2 for the other side. 2 Remove the unit 1 Use a thin screwdriver to push in the clip on the left side of the unit, then pull out the left side of the unit until the catch clears the mounting. 4 mm 2 Repeat step 1 for the right side. 3 Slide the unit out of its mounting. 20 Specifications CD player section Signal-to-noise ratio 90 dB Frequency response 10 – 20,000 Hz Wow and flutter Below measurable limit Tuner section FM Tuning range 87.5 – 108.0 MHz Aerial terminal External aerial connector Intermediate frequency 10.7 MHz/450 kHz Usable sensitivity 8 dBf Selectivity 75 dB at 400 kHz Signal-to-noise ratio 66 dB (stereo), 72 dB (mono) Harmonic distortion at 1 kHz 0.6 % (stereo), 0.3 % (mono) Separation 35 dB at 1 kHz Frequency response 30 – 15,000 Hz MW/LW Tuning range MW: 531 – 1,602 kHz LW: 153 – 279 kHz Aerial terminal External aerial connector Intermediate frequency 10.7 MHz/450 kHz Sensitivity MW: 30 .V LW: 40 .V Power amplifier section Outputs Speaker outputs (sure seal connectors) Speaker impedance 4 – 8 ohms Maximum power output 45 W . 4 (at 4 ohms) General Outputs Audio outputs (CDXL380X/ L400X only) Power aerial relay control lead Inputs Telephone ATT control lead Tone controls Bass ±9 dB at 100 Hz Treble ±9 dB at 10 kHz Power requirements 12 V DC car battery (negative earth) Dimensions Approx. 178 . 50 . 177 mm (w/h/d) Mounting dimensions Approx. 182 . 53 . 162 mm (w/h/d) Mass Approx. 1.2 kg Supplied accessories Parts for installation and connections (1 set) Front panel case (1) Optional accessories Rotary commander RM-X4S (CDX-L410/ L420V only) Design and specifications are subject to change without notice. Troubleshooting The following checklist will help you remedy problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures. General No sound. •Adjust the volume with volume + button. •Cancel the ATT function. •Set the fader control to the centre position for a 2-speaker system. The contents of the memory have been erased. •The RESET button has been pre...
Эта инструкция также подходит к моделям:Автомагнитолы - CDX-L400X (941.51 kb)
Автомагнитолы - CDX-L410 (941.51 kb)
Автомагнитолы - CDX-L420V (941.51 kb)