? The MP3/WMA related text isn’t displayed correctly. . A character is entered that this unit can't display. . For the characters that can be used for MP3/WMA text refer to (page 6). ? The MP3/WMA track time isn’t displayed correctly. . -- . There are times when it isn’t displayed correctly according to the MP3/WMA recording conditions. If the following situations, consult your nearest service center: • Even though the disc changer is connected, the Disc Changer source is not ON, with "AUX" showing in the display during the Changer Mode. • Even though no device (KCA-S210A, CA-C1AX, KDC-CPS87, KDC-CX87, KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is connected, the Auxiliary input is entered when switching modes. The messages condition. Eject: No disc magazine has The disc magazine is not . Load the disc magazine properly. No CD in the unit. . Insert the CD. No Disc: No disc has been loaded in the disc . Load a disc into the disc magazine. TOC Error: The CD is quite dirty. The CD is upside-down. The CD is scratched a lot. . Clean the CD and load it correctly. E-05: The CD is upside-down. . Load the CD correctly. Blank Disc: Nothing has been recorded on the MD. No Track Disc: No tracks are recorded on the MD, although it has a title. No Music Data: Media was played that doesn’t have data recorded that the unit can play. . Use media that has data recorded that the unit can play. No Panel: The faceplate of the slave unit being connected to this unit has been removed. . Replace it. E-77: The unit is malfunctioning for some reason. . Press the reset button on the unit. If the "E-77" code does not disappear, consult your nearest service center. — 47 — 47— 47 — —— English English Mecha Error: Something is wrong unit is malfunctioning . Check the disc magazine. button on the unit. If the not disappear, consult your nearest service Hold Error: The protective circuit in the unit temperature inside the automatic exceeds 60°C (140°F), stopping all . Cool down the unit by opening the windows turning on the air conditioner. As the temperature falls below 60°C (140°F), the disc will start again. NO NAME: Attempted to display DNPS during the CD play having no disc names preset. NO TITLE: Attempted to display the disc title or track title while the MD having no MD title is being played. NO TEXT: • Attempted to display the disc text or track text while the CD having no CD text is being played. • Attempted to display text during reception of the station that isn't sending text data. • Attempted to display the ID3 tag while the MP3/WMA having no ID3 tag is being played. Waiting: Radio text data is being received. Load: Discs are being exchanged in the Disc changer. Reading: The unit is reading the data on the disc. NO ACCESS: After setting it in the Disc Changer, DNPP was done without having it been played at least 1 time. •••••••• IN (Blink): The CD player section . Reinsert the CD. If the display continues to flash been properly reinserted, power and consult your nearest Unsupported File: A MP3/WMA is played with a format support. . --- Protected File: A copy-protected file is played. . --- — 48 — 48— 48 — —— Specifications Specifications FM tuner section Frequency range (50 ..............87.5 MHz – 108.0 Usable sensitivity (S/N = ................................. 0.7 .V/75 . Quieting Sensitivity (S/N = .............................. 1.6 .V/75 . Frequency response ( ± 3.0 dB) ..............................30 Hz – 15 Signal to Noise ratio (MONO) ..............................................65 Selectivity (DIN) ( ± 400 kHz) .............................................. . 80 dB Stereo separation (1 kHz) ....................................................35 dB MW tuner section Frequency range (9 kHz space) .....................531 kHz – 1611 kHz Usable sensitivity (S/N = 20dB) ........................................... 25 .V LW tuner section Frequency range .............................................153 kHz – 281 kHz Usable sensitivity (S/N = 20dB) ........................................... 45 .V CD player section Laser diode ....................................................GaAlAs ( .=780 nm) Digital filter (D/A) ......................................8 Times Over Sampling D/A Converter .......................................................................1 Bit Spindle speed (KDC-PSW9521/ M907/ M9021) ..............................................1000 – 400 rpm (CLV 2times) (KDC-8021) ..........................................500 – 200 rpm (CLV) Wow & Flutter........................................Below Measurable Limit Frequency response ( ± 1 dB) .................................10 Hz – 20 kHz Total harmonic distortion (1 kHz) ......................................0.01 % Signal to Noise ratio (1 kHz) ..............................................105 dB Dynamic range ....................................................................93 dB Channel separation.......................................
)
