Оценок - 4, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
Do the same operation on the other side and pull out the unit from the installation sleeve. 7 8 Connection Diagram POWER AMPLLIFIER CONTROL :REMOTE ON (BLUE/WHITE) PHONE LINE (ORANGE) DIMMER (PINK) DIMMER SWITCH IGNITION SWITCH TO IGNITION (RED) GROUND (BLACK) POWER ANT (BLUE) TO BATTERY : BACK UP (YELLOW) CONTROL RELAY BA C D 1 2 3 4 5 6 7 8 CD CHANGER (optional) s BATTERY POWER ANT (Optional) 1. WHITE 2. WHITE/BLACK STRIPE 3. GRAY 4. GRAY/ BLACK STRIPE 5. GREEN 6. GREEN/ BLACK STRIPE 7. VIOLET 8. VIOLET/ BLACK STRIPE LEFT : WHITE RIGHT: RED 8 Connection Diagram POWER AMPLLIFIER CONTROL :REMOTE ON (BLUE/WHITE) PHONE LINE (ORANGE) DIMMER (PINK) DIMMER SWITCH IGNITION SWITCH TO IGNITION (RED) GROUND (BLACK) POWER ANT (BLUE) TO BATTERY : BACK UP (YELLOW) CONTROL RELAY BA C D 1 2 3 4 5 6 7 8 CD CHANGER (optional) s BATTERY POWER ANT (Optional) 1. WHITE 2. WHITE/BLACK STRIPE 3. GRAY 4. GRAY/ BLACK STRIPE 5. GREEN 6. GREEN/ BLACK STRIPE 7. VIOLET 8. VIOLET/ BLACK STRIPE LEFT : WHITE RIGHT: RED Connection Precaution Before connecting, make sure that ignition switch is set to OFF, and remove the terminal of the battery to avoid short circuits. otes • Make correct connections as illustrated in the connection diagram. • Never use the cord of each speaker in common. A From antenna the Ground. B From power amplifier’s input jack ( 2 channel or 4 channel Optional) Connect the CD changer (optional) • Your car receiver works as control unit for a CD changer which you can buy, if R C To the wiring of vehicle Colors of leads not yet done, later. • The suitable cord shown on the • BLUE/WHITE : This lead is for connection to the power amplifier (Remote on) • ORANGE : This lead is for connection to the Phone line. • YELLOW : This lead is for connection to the Battery (back-up) terminal from which the power is always supplied. • BLUE : This lead is for connection to the full automatic power antenna. Power antenna load to be connected the terminal of the control relay switch for vehicles equipped with a power antenna. This lead is not used for vehicles with manual or semiautomatic antennas. • PINK : This lead is for connection to the Dimmer line • RED : This lead is for connection to the terminal from which the power is supplied when the ignition switch is set to ACC. • BLACK : This lead is for connection to D scheme will be provided together with the CD changer. 2-Speaker Connections LR s 9 FRONT 1 2 3 4 4-Speaker Connections s FRONT REAR 12345678 L L R Detachable Front panel Protective Case dbc baA C D B c Detachable Front panel The front panel of this unit can be detached to prevent theft. a Press the RELEASE ( ) button to open the front panel. b Push the front panel to right. c Pull the front panel. d Place the front panel in the supplied protective case. Attachable Front panel a Join A on the front panel to C D B on the main unit. b Join on the front panel to on the main unit while pushing the front panel to right. c Close the front panel otes • When detaching or attaching the front panel, do not press the display or control buttons. • The control buttons may not work properly if the front panel is not attached properly. If this occurs, gently press the front panel. • Do not leave the front panel in any area exposed to high temperatures or direct sunlight. • Do not drop the front panel or otherwise subject it to strong impact. • Do not allow such volatile agents as benzine, thinner, or insecticides to come into contact with the surface of the front panel. • Do not try to disassemble the front panel. 10 Basic Operation POWER ON and OFF • Press POWER (PWR) button or any other button to turn the unit on. - When you insert the CD in the CD slot, it s turn on • Press POWER (PWR) to turn it off. - When the front panel is opened for more than 30 seconds, it is turned automatically off otes • When you turn off, the unit is memorized automatically the volume level currently before you turn off. • Whenever you turn on the unit, it will operate at the volume level memorized. SOUND Adjustment MUTE FUNCTION • MUTE button is operated as Mute state on/off. • The releasing mode mute state is when any button is pressed again. EQUALIZER (EQ) Button Each press of the EQ button switches the unit to the other equalizer mode, as follows. Popt ttClassict ttRockt ttJazzt ttVocal • Pop : Optimized for R&B, Soul and Country music. • Classic : Optimized for orchestral music. • Rock : Optimized for Hard Rock and Heavy Metal music. • Jazz : Sweet sound with soft feeling • Vocal : Powerful realism width strong sound quality XDSS (Extreme Dynamic Sound System) Press XDSS button to reinforce treble, bass and surround effect. SELECTION (SEL) Button a press the SELECTION (SEL) button repeatedly to select the mode you want to adjust from volume, bass, treble, balance and fader. The mode indicator lights up in the following order. b Turn left or right CONTROL UP/DOWN dial to adjust the sound quality Turn right Turn left VOL Increase the volume level. Decreas...