Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
Keep the screws in a safe place because they will be needed again for fastening the new antenna support. • Now place the mobile antenna support on the joint of the mast and tighten the mast bracket with the aid of an Allen key. • Unscrew the cable from the LNB and pull it out of the cable support on the LNB. • Then screw the LNB cover again to the flat antenna. This will protect the LNB during the transport of the flat antenna. 1. Unscrewing the cable from the LNB 2. Removal of the flat antenna 3. Removal of the mobile antenna support Milled screws Flat antenna LNB-cover Antenna cable with plug Joint Support Mobile antenna support Mast Bracket with 2 hex. socket head screws Lift up the flat antenna Lift up the flat antenna hex. socket head screws Antenna cable 9985-551/798/2.3e hex. socket head screws lf you wish to drive with your vehicle without the flat antenna mounted, but the jointed mast still installed, you should protect the antenna as shown in opposite illustration. • Care for adequate insulation or sealing of the antenna plug. Protect the plug from moisture. • Bend the antenna cable to the form of a loop and introduce the end of the cable into the joint of the mast until the plug has disappeared in the lower part of the joint. Then check if the mobile antenna support is well fixed. lf necessary, tighten the two socket head screws of the bracket. • Place the flat antenna evenly on an appropriate support. • Place the washers on the socket head screws and screw the antenna support to the back of the flat antenna (see opposite illustration). Use for that purpose the 4 socket head screws belonging to the mobile antenna support. • Now screw in with your fingers the 4 socket head screws. Pay attention that they are not twisted and damage the thread. • When positioning the antenna support, make sure that the socket head screws are positioned exactly in the middle of the elongated holes. Then take the short shaft of an Allen key in your hand and screw the socket head screws tight. See opposite illustration. • Then tighten the socket head screws with a torque spanner. The torque moment is 6.5 Nm. lf no torque spanner is available, the following method will do: Take the long shaft of the Allen key in your hand and tighten the socket head screws giving an 1/4 to an 1/2 turn. 6. Notice regarding the polarisation setting The polarisation setting is dependent on the geographic reception site. The annexed mounting instructions „Flat antennas BAS 62 and BAS 63 for stationary use“ explain on page 4 how the polarisation is set. 4. Driving without the mounted flat antenna 5. Mounting the antenna support Mobile antenna support Joint Driving direction Cable binder Cable plug Take the long shaft of the Allen key in your hand and tighten the socket head screws giving an 1/4 to an 1/2 turn. Take the short shaft of the Allen key in your hand and screw the hex. socket screw tight. The hex. socket head screw must be positioned in the middle of the elongated hole of the antenna support Flat antenna 4 hex. socket head screws with washers 9985-551/798/3.3e/H&S Subject to technical changes! Antenna support KATHREIN-Werke KG • Anton-Kathrein-Stra.e 1 - 3 • Postfach 10 04 44 • D-83004 Rosenheim • Deutschland • Telefon (0 80 31) 18 40 • Fax (0 80 31) 18 43 06 ...
Эта инструкция также подходит к моделям:Автомагнитолы - BAS 60 (198.06 kb)