Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
800-477-2267 ext. 230 support@peripheralelectronics.com ©2009 AAMP of Florida, Inc. Rev. 10-28-08 Universal Owner’s Manual IS77 Factory Radio Aftermarket Radio For OR Peripheral Electronics®, a division of AAMP of America™ 13160 56th Court Clearwater, Florida 33760 Ph. 800-477-2267 ext. 230 support@peripheralelectronics.com ©2009 AAMP of Florida, Inc. Rev. 10-28-08 Universal Owner’s Manual IS77 Factory Radio Aftermarket Radio For OR Table of Contents Pages 1. Introduction 1 2. IS77 Components 1 3. Installation Options 1 4. Radio Input Interface (PURI) Installarion 2 5. Troubleshooting 4 6. Warranty Information 5 “Connect to iPod” in the PURI wiring harness. of the driver while operating the automobile. PURIFuse PURIFuse 1. Introduction Thank you for choosing the iSimple IS77 as your audio input solution. The IS77 is designed to provide the connecting link between your audio source and your FM radio. Using the supplied accessories, you can connect virtually any audio source into any FM equipped radio. This interface has a universal input that can be configured to accept an audio signal from any source with an RCA connection or a standard 3.5mm “Headphone” output. The IS77 will route the audio from your device through your factory or aftermarket radio not equipped with a built in auxiliary input. If your audio source is an iPod featuring a docking connector, this interface will also charge the iPod’s battery, when connected. 2. IS77 Components • One Radio Input Interface • One 3.5 mm to 3.5 mm Audio Cable (4ft.) • One 3.5mm to RCA adapter • One Power Cable with a On/Off Switch • One iPod Audio/Video Cable Outputs (5ft.) • One “factory look” 3.5mm Dash/Panel Mount Audio Input Cable (6ft.) 3. Installation Options (Choose A or B) A. Connecting an iPod Antenna Out * Antenna In * PURIConnects to iPod Connects to On/Off Switch MENUiPod Audio Cable (5 ft.) Fuse Fuse iPod (not included) Connect To SWITCH Connect To iPod iPod Specific installation instructions 1) Connect the two audio connectors from the iPod cable to the audio inputs on the PURI. Connects to Connect To 2) Connect the two-pin power connector on the iPod cable to the connector labeled iPod ConectionNot USE OR SWITCH On/Off Switch MP3 (not included) 3/8” hole Antenna Out* 3.5 mm to 3.5 mm 3.5 mm to RCA “factory look” 3.5 mm Audio Cable (4 ft.) Adapter Dash/Panel Mount Antenna In * Audio Input Cable (6 ft.) 4) Route the iPod connector to your chosen iPod location in your automobile. Common audio source locations are the glove box, center console or in a mounted iPod cradle. You will need to (not included) access the iPod in order to change music selections, etc.. 1 3. Connecting a source with RCA outputs B. Connecting a Source with a Headphone or Line Output Installing the 3.5 Dash Panel Mount Audio Input Antenna In * PURI 3. Connecting a source with RCA outputs iPodAudio Cable (5 ft.) 3.5 mm to RCA Adapter Antenna Out* Antenna In * PURI Connects to On/Off Switch Fuse 3.5mm to 3.5mm Audio Cable (4 ft.) “factory look” 3.5 mm Dash/Panel Mount Audio Input Cable (6 ft.) 3/8” hole RCA to RCA (not included) Antenna Out* Antenna In * PURI Connects to On/Off Switch Fuse audio source (not included) MP3 (not included) * Some radios require the addition of antenna connection adapters Connect To SWITCH iPod Conection Not USE Connect To SWITCH iPod Conection Not USE audio source (not included) OR 1) Choose mounting position of dash mount audio input and carefully drill 3/8” mounting hole. Install connector. 2) Connect your audio device to the newly installed audio input via the supplied 3.5 mm to 3.5 mm connection cable. 3.5 mm to 3.5 mm Audio “factory look” 3.5 mm Dash Panel Mount Audio input (6 ft.) Cable (4 ft.) 3/8” 4. Radio Input Interface (PURI) Installation PURI Universal Radio Input Stereo Audio to FM Radio Audio Input . ° L ° R Power 12V DC ° Ground ° . Antenna Input ° Antenna Output ° Tuning Frequency (MHz FM) . 87.9 88.3 Radio Tuning Frequency Use to select best operating frequency for your area Audio Input Left & Right Antenna Out to FM radio* Antenna Input from vehicle antenna* Ground Connection Connect to a clean ground point Factory or Upgraded Radio* On/Off Switch 3/4” mounting hole Connects to Power Source ACC 12VDC 2A Fuse Power when key-on TOP VIEW Gain Adjustment Use to match volume of PURI BACK VIEW L H LEVEL + * Antenna Adapter May be Required 3/4 mountinghole Connects to Power Source ACC 12VDC 2A Fuse Power whenkey-on BACK VIEWHL LEVEL + Gain Adjustment Use to match volume of PURI to volume of FM radio stations 1) The PURI is designed to install Inline with the radio antenna connection usually located on the back of the radio in the dash. In some cases this connection may be at a remote radio tuner location. Consult vehicle manufacturer’s information in these cases. 2) Some antenna connections require the use of an antenna adapter in order to connect to the PURI. These adapters are available from most car audio installation retailers. 3) Select...