Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
MAKE SURE THE UNIT IS MOUNTED WITHIN THIS LIMITATION. SIDE VIEW OF CHASSIS UNSNAP AT 2 PLACES EACH ON TOP AND BOTTOM MAXIMUM SCREW SIZE M5 x 8 MAXIMUM SCREW SIZE M5 x 8 PERFORATED STRAP RADIO SCREW STUD MOUNTING SLEEVE PLASTIC FRAME FACTORY MOUNTING BRACKETS REMOVAL TOOLS BEND BOTTOM TABS DOWNWARD BEND TOP TABS UPWARD TYPICAL INSTALLATION INSTINSTINSTINSTINSTALLALLALLALLALLAAAAATTTTTION INSTRUCION INSTRUCION INSTRUCION INSTRUCION INSTRUCTTTTTIONSIONSIONSIONSIONS 33333 IMPORTANT THE BLUE WIRE CAN BE USED TO REMOTELY ACTIVATE AN AUTOMATIC ANTENNA OR AN EXTERNAL AMPLIFIER (SEE ANTENNA OR AMPLIFIER MANUAL) 9 PIN PLUG (SEE PAGE 5 FOR SPEAKER WIRING) 4 PIN PLUGS POSITIVE (+) TERMINAL 12V BATTERY YELLOW CAR BATTERYMETAL PART OF DASH (DRILL HOLE IF NECESSARY) SCREW BLACK RED “RADIO” FUSE + 12V ACCESSORY BLUE FUSEBLOCK RADIO IMPORTANT YELLOW WIRE MUST BE CONNECTED AS SHOWN OR RADIO WILL NOT OPERATE PROPERLY 1-AMP FUSE EXISTING ANTENNA CABLE ANTENNA ANTENNA CONNECTOR ANTENNA PLUG FILTER/FUSE BOX 15-AMP FUSE IMPORTANT THE BLUE WIRE CAN BE USED TO REMOTELY ACTIVATE AN AUTOMATIC ANTENNA OR AN EXTERNAL AMPLIFIER (SEE ANTENNA OR AMPLIFIER MANUAL) 9 PIN PLUG (SEE PAGE 5 FOR SPEAKER WIRING) 4 PIN PLUGS POSITIVE (+) TERMINAL 12V BATTERY YELLOW CAR BATTERYMETAL PART OF DASH (DRILL HOLE IF NECESSARY) SCREW BLACK RED “RADIO” FUSE + 12V ACCESSORY BLUE FUSEBLOCK RADIO IMPORTANT YELLOW WIRE MUST BE CONNECTED AS SHOWN OR RADIO WILL NOT OPERATE PROPERLY 1-AMP FUSE EXISTING ANTENNA CABLE ANTENNA ANTENNA CONNECTOR ANTENNA PLUG FILTER/FUSE BOX 15-AMP FUSE 44444RRRRRAAAAADIO WIRINGDIO WIRINGDIO WIRINGDIO WIRINGDIO WIRING RADIO WIRING RADIO WIRINGRADIO WIRINGRADIO WIRINGRADIO WIRINGRADIO WIRING REFER TO PAGE 5 FOR SPEAKER WIRING AUTOMATIC ANTENNA RCA LINE OUT JACK TO OPTIONAL SUBWOOFER SPEAKER GRN SPESPESPESPESPEAKER WIRINGER WIRING SPEAKER WIRING REFER TO PAGE 4 FOR RADIO WIRING WARNING! ! THE AMPLIFIERS IN THIS RADIO ARE ONLY DESIGNED FOR USE WITH 4 SPEAKERS. ! NEVER COMBINE (BRIDGE) OUTPUTS FOR USE WITH 2 SPEAKERS. ! NEVER GROUND NEGATIVE SPEAKER LEADS TO CHASSIS GROUND. ! FAILURE TO WIRE EXACTLY AS SHOWN BELOW MAY CAUSE ELECTRICAL DAMAGE TO THE RADIO. OPTIONAL CD CHANGER WHITE w/BLACK STRIPE WHITE LEFT FRONT SPEAKER RIGHT FRONT SPEAKER LEFT REAR SPEAKER RIGHT REAR SPEAKER GREEN GRAY w/BLACK STRIPE 9-PIN PLUGS GREEN w/BLACK STRIPE VIOLET w/BLACK STRIPE RADIO 8:30am - 7:00pm Eastern 9:00am - 5:00pm Eastern Monday - Friday Saturday 1-800-645-4994 HELP! GRAY VIOLET 4-PIN PLUGS SEE PAGE 4 FOR RADIO WIRING 8-PIN DIN SOCKET FOR CONNECTION TO OPTIONAL CD CHANGER 6 COMPACT DIN CABLE (SUPPLIED WITH CD CHANGER). NOTE: CALL 1-800-645-4994 FOR RECOMMENDATIONS OF MODEL CHANGERS THAT WILL WORK WITH YOUR RADIO. WHITE = LEFT RED = RIGHT RCA LINE OUT JACKS FOR USE WITH OPTIONAL EXTERNAL AMPLIFIERS RCA LINE IN JACKS FOR USE WITH AUXILIARY INPUT DEVICES (CD PLAYER, ETC.) BLK GREY 5 OPER OPEROPEROPEROPEROPERA AAAAAT TTTTTING INSTRUC ING INSTRUCING INSTRUCING INSTRUCING INSTRUCING INSTRUCT TTTTTIONS IONSIONSIONSIONSIONS 6OPEROPEROPEROPEROPERAAAAATTTTTING INSTRUCING INSTRUCING INSTRUCING INSTRUCING INSTRUCTTTTTIONSIONSIONSIONSIONS 2 3 4 5 6 7 8, 10 9 11 12 21 22 37 38 1718 29 31 28 15 32, 33 BEHIND PANEL201934 13 27 35 23 39 24 40 25 41 16 1 30 14 26 36 CAR COMPACT DISC PLAYER/RECEIVER SUB 1 11111ON-OFF POWER BUTTON Press this button to turn the unit on and off when the ignition switch is on. When the unit is off, the Liquid Crystal Display (LCD) panel will normally display the time-of-day. If the radio is off when the ignition switch is turned off, the POWER button must be pressed to turn on the radio after the ignition switch is turned on. If the ignition switch is turned off while the radio is on, the radio will come on automatically when the ignition switch is again turned on. 2 22222VOLUME LEVEL CONTROL To increase the volume level, rotate the PUSH SELECT-VOL control clockwise (CW). The volume will increase and the level will be shown on the display panel from a minimum of 00 to a maximum of 100. To decrease the volume level, rotate the PUSH SELECT-VOL control counterclockwise (CCW). The volume will decrease as shown on the display panel. This control also includes the integral Select button 3 for adjustment of the bass, treble, balance and fader levels as described in 4, 5, 6, and 7. 3 33333PUSH SELECT BUTTON (SEL) This button is used to select the audio function (bass, treble, balance, or fade) to be adjusted using the Volume Level control 2. Pressing the Select button once will set the unit for volume adjustment (VOL will appear on the display panel). Pressing the button additional times will select bass adjustment (BAS on display), treble (TRB), balance (BAL), or fader (FAD). The display will automatically return to the normal indication 5 seconds after the last adjustment or when another function is activated. NOTE: If the BAS or TRB functions are set while the Equalizer function (EQ) is active, the Equalizer function will automatically revert to...