Оценок - 1, средний балл: 5
(
)
)
|
Фрагмент инструкции
The Random Play mode can be cancelled by pressing the button again for 2 seconds (RND indication will disappear from the display panel) or by activating the Track Intro-Scan (INT) or Repeat (RPT) function. co cococococo DISC EJECT ( ) BUTTON When pressed, disc play is stopped and the disc is automatically ejected; will disappear from the display panel and the unit will revert to radio operation. If the disc is not removed from the unit, it will automatically be reloaded within 10 seconds to prevent accidental disc damage. The icon will remain displayed to indicate a disc is still loaded in the unit. NOTE: Always remove the disc from the unit when the disc player is not to be used for an extended period of time to prevent accidental disc damage and to preserve disc life. cp cpcpcpcpcp TIME/FREQUENCY SELECTOR (T/F) This unit can display either the clock time or radio frequency/CD player functions. Ordinarily, the radio frequency or CD player track indication is displayed, but the display can also show the time when this button is pressed. The time will then be displayed for approximately 5 seconds after which it will return to the radio or CD player function display. 128-6496 10 of 16 The correct time-of-day can also be set into the following circumstances as it will erase the unit by pressing the Time/Frequency Selector time memory: button. This procedure is outlined later in these 1. Upon initial installation after all wiring is operating instructions. completed. 2. If there is a malfunction of any of the cq cqcqcqcqcq THEFT-DETERRENT LED switches on the unit, pressing the RELocated on the chassis behind the front panel, a SET button may clear the system and light-emitting diode (LED) will flash when the return to normal operation. panel is physically removed. The flashing cs cscscscscs PANEL RELEASE (REL) BUTTON lightserves as a visual warning to the would-be This button ( ) is used to release the thief that the unit has been disabled by removal mechanism that holds the front panel to the of the front panel. chassis. To detach the front panel, press the button so that the right side of the panel cr crcrcrcrcr RESET BUTTON releases outward. Grasp the panel at the right A Reset button is located on the front panel of the side and disengage it from the left side of the unit in the extreme lower right corner. The Reset chassis. To re-attach the panel, engage the function is provided to protect the microproces left side onto the chassis; then gently press in sor circuitry and should only be activated under the the right side until it clicks and locks into place. place. CD PL CD PLCD PLCD PLCD PLCD PLA AAAAAYER ERR YER ERRYER ERRYER ERRYER ERRYER ERROR CODES OR CODESOR CODESOR CODESOR CODESOR CODES If a problem should develop while operating the CD player, an error code (ER-1, ER-2, ER-3, etc.) may appear on the display panel. This can indicate a number of problems with the unit, including a mechanical error or an error in the microprocessor control of the player. If an error code should appear, try ejecting and reloading the disc into the player. While the disc is out of the unit, make sure it is clean, undamaged, and loaded correctly (label surface up). You may also try activating the RESET button cqon the unit, but this will also erase the time memory. If the suggested measures do not solve the problem, contact an approved warranty station near you for further assistance. SET SETSETSETSETSETT TTTTTING THE CLOCK ING THE CLOCKING THE CLOCKING THE CLOCKING THE CLOCKING THE CLOCK 1. Turn the vehicle ignition and radio on. 2. Press and hold the Time/Frequency button cp cpcpcpcpcp for approximately 2 seconds; the time display will begin to flash. 3. Within 5 seconds of selecting the flashing display, press the VOL + button to adjust the hours and the AM/PM indication to the desired setting. 4. Press the VOL - button to adjust the minutes to the desired time. 4. Five seconds after the last hour or minute adjustment is made, the time will be set in the unit and normal operation will resume. 128-6496 11 of 16 1111111111 OPEROPEROPEROPEROPERAAAAATTTTTING INSTRUCING INSTRUCING INSTRUCING INSTRUCING INSTRUCTTTTTI0NSI0NSI0NSI0NSI0NSERROR CODE / ERROR CODE / ERROR CODE / ERROR CODE / ERROR CODE / 1212121212 SPECIFICASPECIFICASPECIFICASPECIFICASPECIFICATTTTTIONSIONSIONSIONSIONS1212121212 SPECIFICASPECIFICASPECIFICASPECIFICASPECIFICATTTTTIONSIONSIONSIONSIONS SPECIFICATIONS SPECIFICATIONSSPECIFICATIONSSPECIFICATIONSSPECIFICATIONSSPECIFICATIONS Size: 7" W x 2" H x 6-1/8" D 178 mm x 50 mm x 155 mm Operating Voltage: 12 volts DC, negative ground Fuse Ratings: Constant (yellow) lead: 15 AMP. Switched (red) lead: 0.5 AMP. Output Power: 140 watts maximum ( 35 watts x 4 channels) Output Wiring: Floating-ground type designed for 4 speaker use. Output Impedance: Compatible with 4-8 ohm speakers. Tuning Range: AM: 519 – 1,735 kHz. FM: 87.3– 108.5 MHz. Sensitivity: AM: 20 uv. FM: 1.5 uv. FM Stereo Separation: > 25 dB CD Frequency Respon...