Оценок - 2, средний балл: 5
(
)
)
|
Фрагмент инструкции
SCAN BUTTON (M2) To "Intro" each song on the disc for 10 seconds, press the " INTRO" button. INT will appear in the display area. To turn off this feature, press the " Intro" button again. The indicator in the display will be off. TRACK REPEAT PLAY SELECTOR (RPT) (M3) During disc play, pres this button to repeat the play of the selected track (RPT will appear on the display panel). Play of the track will continue to repeat until the buttonis pressed again and the RPT indication disappears from the display panel. RDM BUTTON (M4) To play the songs on the disc in a random order (other than the original recorded order), press the " RANDOM" button. To turn off this feature, press the " RANDOM" button again. The indicator RDM in the display will be off. DISC UP/DOWN (M5/M6) This key is for search up and down the disc of magazine in the CDC mode. AUDIO SELECT KEY This key select audio mode as shown in below sequence. If no volume up/down key is pressed in bass/tre/bal/fad mode, it is retuned to volume selcet mode (inital) 5 secretary later. VOLUME BASS TREBLE BALANCE FADER VOLUME Increase or decrease the volume by pressing " + " or " -" .The volume + or-keys canalso be used to adjust the bass/treble/bal/fade controls in the same manner. MUTE KEY * This key is used in any mode to mute audio output. In the mute state, "MUTE" flashes in the display and all 4 channels of the audio output are muted . * The mute function is released by pressing any of the following buttons: mute, power, volume up or down, loud, or turning the vehicle off. LO/DX KEY * This key is valid in radio mode and toggles LO/DX output and 'LOC' display. Local : LO/DX output=High, 'LOC' on Dx (initial) : LO/DX output = Low, 'LOC' off APPLICATION NOTES This note will discuss DC Power sources and how they relate to 12 volt products. General Specifications Our general specification for the voltage range of operation is 10 to 16 volts DC . Voltage The voltage of a fully charged battery ( engine not running ) is approximately 12.5 VDC. Once a load (items being powered represent the "load" ) is applied , the voltage will drop. How much the voltage is reduced will depend on the following: 1. Current draw (amount of amperage) The higher the draw the greater the voltage will drop. 2. The size and length of the conductor (wire) supplying power. Converters Many boats incorporate convertors as a source for 12VDC when connected to shore power (110-120 VAC).Some converters put out a very clean DC supply where others may have a considerable amount of AC ripple noise under maximum load. The AC ripple noise is filtered by the boat battery when connected into the circuit , but when the battery is disconnected the amount of AC ripple noise can create major problems for audio products. Noise may result and the line fuse may fail Ignition systems Unwanted noise generated from ignition systems used to be a big problem. However, with more sophisticated filtering circuits designed into audio/video products, these problems are not as wide spread Changes in wire harnessing also has contributed to the decline of application problems. Use the same ground point for all related products. This will greatly reduce the potential for unwanted noise. Your MS160 radio is designed to control an optional 10 Disc CD changer ( Model ACC56M ) . If you are interested in purchasing thisdealer . Professirecommended. CD changer, please visit youronal installation of the CD local marine changer is 6 WIRING DIAGRAM (Figure 2) CONNECTIONS REAR LEFT SPEAKER REAR RIGHT SPEAKER SPECIFICATIONS Size: 7"(W) x 2" (H) x 6 1/8"(D) 178mm x 50mm x 166mm Operating Voltage: 12VDC, Negative Ground Output Power: 4x25 W Max. Stereo Power Output Impedance: Compatible with 4 or 8 ohm speaker. Tuning Range: (AM) 530-1710KHz (FM) 87.5-107.9MHz Sensitivity: (AM) less than 25uV (FM) less than 5uV FM Stereo Separation: More than 23 dB Frequency Response: 50-10000Hz OPTIONAL CD CHANGER (ACC56M) AUX INPUT CONNECTOR UNIT ANTENNA BLUE POWER ANT RED B+ FUSE (ACC) BLACK GROUND (-) GREEN W/BLACK VIOLET W/BLACK WHITE GREY WHITE W/BLACK GREY W/BLACK FRONT LEFT SPEAKER FRONT RIGHT SPEAKER GREEN VIOLET TROUBLESHOOTING CHART AM/FM RADIOS Symptom Cause Possible Solution No Power No 12VDC Check circuit fuse at source Check in-line fuse on power lead Power lead disconnected Ground connection disconnected Power indicated; no audio output or very distorted sound No 12VDC to memory lead(electronically tuned units only) Circuit fuse at source In-line memory lead fuse Speaker Output shorted Check continuity of speaker leads to ground Speaker out cross channeled Check for proper speaker wiring Note: Radios have a sticker on them explaining wiring color code. Only one channel (right or left side) Radio Balance Check radio fu...