Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
Tip
– See the User Manual for how to
1 Connect the AC power cord of the subwoofer to the AC outlet.
connect other equipment to this
system.
– Use the supplied AC power
2
adaptor only! Using any other
Connect the AC power adaptor of the system.
power connection device may
damage your main set!
In case the wireless connection fails due to conflict or strong
interference etc., you may need the following procedures for
manual pairing:
1 In standby mode, press and hold 2; on the set for three seconds to
activate signal transmitting.
➜“PAIR” flashes on the display screen.
2 Press and hold the PAIR button on the rear of the subwoofer for
1
three seconds to activate signal receiving.
➜The LED indicator on the subwoofer flashes in blue and green
alternatively.
● If the connection succeeds, the display shows “PASS”.
● If the connection fails or the connection cannot be set up successfully
within 60 seconds, the display shows “FAIL”.
2
Setting the clock
1 In standby mode, press and hold PROG/SET TIME on the remote control.
2 Press VOLUME +/- (or VOL +/- on the remote control) to switch
between 12 hour and 24 hour display.
3 Press PROG/SET TIME on the remote control again to confirm.
➜ The clock digits flash on the display panel.
4
Press VOLUME +/- (or VOL +/- on the remote control) to set the hours.
5 Press PROG/SET TIME on the remote control again.
➜ The clock digits for the minutes flash.
6 Press VOLUME +/- (or VOL +/- on the remote control) to
set the minutes.
7
Press PROG/SET TIME on the remote control to confirm the time.
DC912_37_QSG_Eng
2
8/25/08, 10:31
...