Оценок - 3, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
• The battery is consumed more quickly than usual when operating the unit continuously or operating it in a cold place. • When the power is supplied using the batteries, the display will be blank when the unit is turned off (at standby). • When the power is supplied using the batteries, the unit is turned on by pressing or source buttons on the main unit. CAUTION To avoid battery leakage or explosion, handle batteries properly. • If you are not going to use this unit for a month or more, remove the batteries from the battery compartment. • Dispose of batteries in the proper manner, according to federal, state, and local regulations. • Do not mix with batteries of different types or with new and old ones. • Do not attempt to charge any batteries other than rechargeable ones. • Discard leaky batteries immediately. Battery leakage can cause skin burns or other personal injuries. • If chemicals leak onto the unit, clean the unit completely. Match the polarities (+ and –) of the batteries. Remote control • If the range or effectiveness of the remote control decreases, replace the batteries. Connecting the power cord Battery compartment Discs CDs with one of the marks below on the surface. Files Files in audio CD format, MP3/WMA files on a finalized CD-R or CD-RW. MP3/WMA files in a USB device can also be played. Playable discs/files Hierarchy Level 1 Level 2 Level 3 Level 4 Level 5 Folder with its play order MP3/WMA track with its play order MP3/WMA folders/tracks configuration • MP3/WMA discs require a longer readout time than regular CDs. (It depends on the complexity of the folder/file configuration.) • Some MP3/WMA files cannot be played back and will be skipped. This results from their recording processes and conditions. • When making MP3/WMA discs, use ISO 9660 Level 1 for the disc format. • This unit can play back MP3/WMA files with the extension code <.mp3> or <.wma> (regardless of the letter case upper/lower). • It is recommended that you make each MP3 file at a sampling rate of 44.1 kHz and at a bit rate of 128 kbps. Similarly each WMA file at a sampling rate of 44.1 kHz and at a bit rate of 96 kbps. • Playback order of MP3/ WMA files may be different from the one you have intended when recording. If a folder does not contain MP3/ WMA files, it is ignored. • This unit cannot play “packet write” discs. • If a CD-RW has been recorded in a different format, erase all data on the CD-RW completely before recording on it. • This unit can recognize up to a total of 511 tracks and folders on a disc, and 65536 files in up to 200 groups (maximum 500 files in a single group) on a USB device. For connecting/disconnecting: • USB Memory and DAPs compatible with the USB mass storage class specifications are connectable. • Always set the volume to the minimum level when connecting or disconnecting a USB device. • When connecting with a USB cable, use the USB 2.0 cable less than 1 m (3.28 ft) in length. • You cannot connect a computer to the USB MEMORY terminal of the unit. • Connect one USB device to the unit at a time. Do not use a USB hub. • When the power is supplied through the AC outlet and USB is selected as the source, the USB device is charged through the USB MEMORY terminal, however some USB devices may not be charged. For playing back: • When connecting a USB device, refer also to its manual. • You can play back MP3/WMA files on a USB device (maximum data transfer rate: 2 Mbps). This unit may not play back some files even though their formats are listed above. • While playing back a file in a USB device, do not disconnect the USB device. It may cause malfunction of both this unit and the device. • This unit is compatible with USB 2.0 Full Speed. • You cannot play back a file larger than 2 Gigabytes. • When playing a file of a large transfer rate, sounds may be dropped during playback. • This unit cannot recognize a USB mass storage class device whose rating exceeds 5V/500 mA. • You cannot send any data to your USB device from this unit. • Some USB devices may not be recognized or may not work properly. • Some DAPs are not compatible with the unit. • Copyrighted tracks (WMA-DRM* tracks) cannot be played back on the unit. • Coded or encrypted tracks in a special method cannot be played on the unit. • Electrostatic shock at connecting a USB device may cause abnormal playback of the device. In this case, disconnect the USB device then reset this unit and the USB device. • JVC bears no responsibility for any loss of data in the USB mass storage class device while using this unit. * DRM (Digital Rights Management): Any of several technical methods used to control or restrict the use of digital media content on electronic devices with such technologies installed. • Compatible iPod: iPod model iPod nano iPod nano (2nd Generation) iPod nano (3rd Generation) iPod nano (4th Generation) iPod mini iPod mini (2nd Generation) iPod (4th Generation) iPod classic iPod photo (4th Generation) iPod video (5th Generation) iPod to...